To Ensure Safety - Shimano Non Series Dealer's Manual

TO ENSURE SAFETY

TO ENSURE SAFETY
DANGER
Be sure to also inform users of the following:
Be sure to observe the following instructions in order to avoid burns or other injury
from fluid leakage, overheating, fire, or explosion.
• Use the designated battery charger to charge the battery. If any non-specified items are
used, fire, overheating or leakage may occur.
• Do not heat the battery or expose it to flames. If this is not observed, combustion or
bursting of the battery may occur.
• Do not deform, modify, disassemble, or apply solder directly to the battery. Do not use or
leave the battery in places which may exceed 60°C in temperature, such as places which
are exposed to direct sunlight, inside vehicles on hot days or near stoves. If this is not
observed, leakages, overheating or bursting may cause fire, burns, or other injuries.
• Do not connect the (+) and (-) terminals with metallic objects. Do not carry or store the
battery together with metallic objects such as necklaces or hairpins. If this is not
observed, short-circuits, overheating, burns or other injury may occur.
• If any liquid leaking from the battery gets into the eyes, immediately wash the affected
area with clean water without rubbing the eyes, then seek medical attention. If this is
not done, blindness may occur.
WARNING
• Be sure to follow the instructions provided in the manuals when installing the product.
Only use SHIMANO genuine parts. If a component or replacement part is incorrectly
assembled or adjusted, it can lead to component failure and cause the rider to lose
control and crash.
•
Wear approved eye protection while performing maintenance tasks such as
replacing components.
Be sure to also inform users of the following:
• Do not place the battery into fresh water or sea water, and do not allow the battery
terminals to get wet. Doing otherwise may cause it to overheat, burst, or ignite.
• Do not use the battery if it has any noticeable scratches or other external damage. If this
is not observed, bursting, overheating or problems with operation may occur.
• Do not throw or subject the battery to strong shock. If this is not observed, bursting,
overheating or problems with operation may occur.
4