Security Lock Function; Settings Backup Function; Reset Function - Sanyo MPX-CD4P Instruction Manual

BASIC OPERATIONS

SECURITY LOCK FUNCTION

This function lets you lock the camera live picture mode or VCR
playback mode, so that it cannot be switched to another mode.
Camera Live Picture Mode Lock
Press the LIVE button for about 3 seconds.
A buzzer will be heard, and the VCR and MENU buttons will not
operate if pressed. If the buttons are pressed, a buzzer will be
heard.
LIVE
VCR Playback Mode Lock
Press the VCR button for about 3 seconds.
A buzzer will be heard, and the LIVE and MENU buttons will not
operate if pressed. If the buttons are pressed, a buzzer will be
heard.
VCR
Canceling the Security Lock
To cancel the security lock, press the same (LIVE or VCR)
button again for about 3 seconds. A buzzer will be heard and the
mode will be unlocked.

SETTINGS BACKUP FUNCTION

This unit is equipped with a backup battery (lithium battery) to
maintain the clock settings. When the unit is used under normal
conditions, the backup battery is recharged. The battery is fully
recharged after a minimum of about 30 hours, and will maintain
the clock settings for up to 30 days.
NOTE: The settings may not be maintained properly if the
backup battery has been recharged for less than 30
hours when the power goes off.
Battery Life
If the power is turned off for about one hour or more, when the
power is restored, the (CLOCK SET) menu is displayed so the
clock settings can be checked.
If the clock settings are reset to: 01-01-2000 SAT 00:00:00, that
may indicate that the battery is dead and must be replaced.
Replacing the Battery
To replace the battery, please consult your dealer. After the
battery has been replaced, press the ALL RESET button, then
in the (CLOCK SET) menu set the date and time (see page 23).
VCR MENU
LIVE MENU

RESET FUNCTION

The menus can be reset or cleared.
LIVE VCR
Using the MENU RESET Button
A: While a menu is displayed, press the MENU RESET button
to reset all the values of the displayed menu to the default
values.
B: If no menu is displayed, press the MENU RESET button to
reset the time to the nearest hour.
For example, between 10:30:00 and 11:29:59 the clock
will be reset to 11:00:00.
Using the ALL RESET button
Press this button to reset the following:
• Reset the time and date in the (CLOCK SET) menu to the
default setting.
•
The display mode on monitor 1 will return to 4 divisions split
screen (default mode).
•
The display mode on monitor 2 will return to sequential, full
screen (default mode).
NOTE: If the multiplexer does not function properly, press
the ALL RESET button.
Please note that all the settings mentioned above
will be reset.
8
ALL RESET
MENU
MENU RESET
English