Related Manuals for Seagate ST1000UM000
Summary of Contents for Seagate ST1000UM000
- Page 1 Laptop SSHD SATA Product Manual Standard models ST1000UM000 ST750UM000 100725145, Rev. E Gen 1 - September 2015...
- Page 2 Seagate, Seagate Technology and the Spiral logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. 3D Defense System and SeaTools are either trademarks or registered trademarks of Seagate Technology LLC or one of its affiliated companies in the United States and/or other countries. The FIPS logo is a certification mark of NIST, which does not imply product endorsement by NIST, the U.S., or Canadian governments.
-
Page 3: Table Of Contents
Seagate® Technology Support Services ........ - Page 4 Mounting Dimensions (for standard models))........... 17 Seagate Laptop SSHD SATA Product Manual, Rev. E...
-
Page 5: Seagate Technology Support Services
For information regarding online support and services, visit: http://www.seagate.com/contacts/ For information regarding Warranty Support, visit: http://www.seagate.com/support/warranty-and-replacements/ For information regarding data recovery services, visit: http://www.seagate.com/services-software/seagate-recovery- services/recover/ For Seagate OEM, Distribution partner portal and reseller portal, visit: http://www.seagate.com/partners/ Seagate Laptop SSHD SATA Product Manual, Rev. E... -
Page 6: Introduction
Introduction ® This manual describes the functional, mechanical and interface specifications for the following Seagate Laptop SSHD model drives: Standard models ST1000UM000 ST750UM000 These drives provide the following key features: 5400-RPM spindle speed. 64MB buffer. 16GB NAND flash For improved reliability, Seagate SSHDs incorporate a technique referred... -
Page 7: Drive Specifications
5% to 95% (nonoperating) Relative humidity gradient 30% per hour max 37.7°C max (operating) Wet bulb temperature (max) 40.0°C max (nonoperating) Altitude, operating –304.8 m to 3048 m (–1000 ft to 10,000+ ft) Seagate Laptop SSHD SATA Product Manual, Rev. E... -
Page 8: Formatted Capacity
Refer to Configuring and Mounting the Drive on page 16 (words 60-61 and 100-103) for additional information about 48-bit addressing support of drives with capacities over 137 GB. Seagate Laptop SSHD SATA Product Manual, Rev. E... -
Page 9: Physical Organization
However, due to the manner in which these drives are formatted, benchmark tests Note that include command overhead or measure logical seeks may produce results that vary from these specifications. Seagate Laptop SSHD SATA Product Manual, Rev. E... -
Page 10: Start/Stop Times
During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Standby power is measured at steady state (after 200ms from transition) Seagate Laptop SSHD SATA Product Manual, Rev. E... -
Page 11: Conducted Noise
Using 5-volt power, the drive is expected to operate with a maximum of 100 mV peak-to-peak square-wave injected noise at up to 10 MHz. Note Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write current. 2.7.3 Voltage tolerance Voltage tolerance (including noise): +5V ± 5% Seagate Laptop SSHD SATA Product Manual, Rev. E... -
Page 12: Power Management Modes
Environmental Specifications This section provides the temperature, humidity, shock, and vibration specifications for Seagate Laptop SSHD drives. Ambient temperature is defined as the temperature of the environment immediately surrounding the drive. Above 1000 feet (305 meters), the maximum temperature is derated linearly by 1°C every 1000 feet. -
Page 13: Shock
Test for prominent discrete tones (PDTs) Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of the absolute threshold of hearing. Seagate uses the lower limit for the threshold curve* to discern tone audibility and to compensate for the inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74 standards. -
Page 14: Electromagnetic Immunity
From this page, click on the “Is my Drive under Warranty” link. Users will be asked to pro- vide the drive serial number, model number (or part number) and country of purchase. The system will display the warranty information for the drive. Seagate Laptop SSHD SATA Product Manual, Rev. E... -
Page 15: Agency Certification
Equipment (ITE). Emission levels are defined by EN 55022, Class B and the immunity levels are defined by EN 55024. Drives are tested in representative end-user systems. Although CE-marked Seagate drives comply with the directives when used in the test systems, we cannot guarantee that all systems will comply with the directives. -
Page 16: Environmental Protection
Users should use caution exposing any electronic components to uncontrolled chemical pollutants and corrosive chemicals as electronic drive component reliability can be affected by the installation environment. The silver, copper, nickel and gold films used in Seagate products are especially sensitive to the presence of sulfide, chloride, and nitrate contaminants. Sulfur is found to be the most damaging. In addition, electronic components should never be exposed to condensing water on the surface of the printed circuit board assembly (PCBA) or exposed to an ambient relative humidity greater than 95%. -
Page 17: Configuring And Mounting The Drive
Signal cable Power cable Each cable is keyed to ensure correct orientation. Seagate Laptop SSHD SATA drives support latching SATA connectors. Drive Mounting Users can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom-mounting holes. Refer to Figure 3 for drive mounting dimensions. - Page 18 0.370 ± .008 in 9.50 ± 0.20 mm 3.567 in 90.602 mm 0.551 in 13.995 mm 2.430 in 61.722 mm 0.160 in 4.064 mm For reference only. May not represent actual drive. Note Seagate Laptop SSHD SATA Product Manual, Rev. E...
-
Page 19: Serial Ata (Sata) Interface
Hot-Plug Compatibility Seagate Laptop SSHD SATA drives incorporate connectors which enable users to hot plug these drives in accordance with the Serial ATA: High Speed Serialized AT Attachment specification revision 2.0. This specification can be downloaded from www.serialata.org. This device requires a COMRESET from the host after a hotplug event. -
Page 20: Supported Ata Commands
Set Max Features register as defined to the right. Password: Lock: Unlock: Freeze Lock: Set Max Address Ext Set Multiple Mode S.M.A.R.T. Disable Operations B0h/D9h S.M.A.R.T. Enable/Disable Autosave B0h/D2h Seagate Laptop SSHD SATA Product Manual, Rev. E... - Page 21 ATA-standard power-management commands Check Power Mode Idle Idle Immediate Sleep Standby Standby Immediate ATA-standard security commands Security Set Password Security Unlock Security Erase Prepare Security Erase Unit Security Freeze Lock Security Disable Password Seagate Laptop SSHD SATA Product Manual, Rev. E...
-
Page 22: Identify Device Command
The maximum value that shall be placed in this field is ST750UM000 = 0FFFFFFFh 0FFFFFFFh. The 0FFFFFFFh value applies to all capacities over 137GB (see Section 2.1 for related information). Retired 0000 Seagate Laptop SSHD SATA Product Manual, Rev. E... - Page 23 These words are required for drives that support the 48-bit addressing ST750UM000 = 1,465,149,168 feature. Maximum value: 0000FFFFFFFFFFFFh. Streaming Transfer Time - PIO 0000 Reserved 0000 Physical sector size / Logical sector size 6003 Seagate reserved 0000 Seagate Laptop SSHD SATA Product Manual, Rev. E...
- Page 24 Ultra DMA mode 0 is currently active. Ultra DMA mode 1 is currently active. Ultra DMA mode 2 is currently active. Ultra DMA mode 3 is currently active. Ultra DMA mode 4 is currently active. Seagate Laptop SSHD SATA Product Manual, Rev. E...
-
Page 25: Set Features Command
Disable the Free Fall Protection feature (41 above enables the Free Fall Protection feature) Report full capacity available Note At power-on, or after a hardware or software reset, the default values of the features are as indicated above Seagate Laptop SSHD SATA Product Manual, Rev. E... -
Page 26: S.m.a.r.t. Commands
S.M.A.R.T. Disable Operations S.M.A.R.T. Return Status If an appropriate code is not written to the Features Register, the Note command is aborted and 0x 04 (abort) is written to the Error register. Seagate Laptop SSHD SATA Product Manual, Rev. E... - Page 27 ASIA/PACIFIC Seagate Singapore International Headquarters Pte. Ltd. 7000 Ang Mo Kio Avenue 5, Singapore 569877, 65-6485-3888 EUROPE, MIDDLE EAST AND AFRICA Seagate Technology SAS 16-18 rue du Dôme, 92100 Boulogne-Billancourt, France, 33 1-4186 10 00 Publication Number: 100725145, Rev. E...
Need help?
Do you have a question about the ST1000UM000 and is the answer not in the manual?
Questions and answers