Siemens WM10J180GC User Manual And Installation Instructions page 43

Errors
The programme does not
start.
The door cannot be opened. "– ––" is activated.
The water is not draining.
Cause
Childproof lock is activated.
Ready in is activated.
Laundry is caught in the
door.
The temperature is too high.
Water level is too high.
Power failure.
Drain pipe or water outlet
hose is blocked.
Drain pipe or water drain
hose is caught or jammed.
Drain pump is blocked.
"– ––" is activated.
Troubleshooting en
Troubleshooting
Press Start / Reload to start the
2.
programme.
→ "Deactivating the childproof
▶
lock", Page 32
Check whether Ready in is activ-
▶
ated.
→ "Buttons", Page 24
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press Start / Reload to start the
4.
programme.
Continue the programme by select-
▶
ing Spin ‫ تفريغ‬or Drain ‫ تفريغ‬and
pressing Start / Reload.
→ "Resuming the programme when
the programme status is Rinse
Hold", Page 31
Wait until the temperature has
▶
dropped.
→ "Cancelling the programme",
▶
Page 31
Start the Drain ‫ تفريغ‬programme.
▶
Open the door using the emergency
▶
release.
→ "Emergency release", Page 48
Clean the drain pipe and the water
▶
outlet hose.
Ensure that the drain pipe and wa-
▶
ter drain hose are not kinked or
trapped.
→ "Cleaning the drain pump",
▶
Page 35
Continue the programme by select-
▶
ing Spin ‫ تفريغ‬or Drain ‫ تفريغ‬and
pressing Start / Reload.
→ "Resuming the programme when
the programme status is Rinse
Hold", Page 31
43