Boreal brisa BRS09HPL1IA Owner's Manual page 17

Introduction for buttons on remote controller
Note:
● For preventing cold air, after starting up heating mode, indoor unit will delay 1~5
minutes to blow air (actual delay time is depend on indoor ambient temperature).
● Set temperature range from remote controller: 16~30℃ (61-86°F);
Fan speed: auto, low speed, medium speed, high speed.
3
FAN button
Pressing this button can set fan speed circularly as: auto (AUTO), low(
( ), high(
Note:
● Under AUTO speed, air conditioner will select proper fan speed automatically
according to ex-factory setting.
● It's Low fan speed under Dry mode.
●
X-FAN function Hold fan speed button for 2s in COOL or DRY mode, the icon "
displayed and the indoor fan will continue operation for a few minutes in order to dry
the indoor unit even though you have turned off the unit. After energization, X-FAN
OFF is defaulted. X-FAN is not available in AUTO, FAN or HEAT mode.
This function indicates that moisture on evaporator of indoor unit will be blowed
after the unit is stopped to avoid mould.
Having set X-FAN function on: After turning off the unit by pressing ON/OFF
●
button indoor fan will continue running for a few minutes. at low speed. In this
period, Hold fan speed button for 2s to stop indoor fan directly.
Having set X-FAN function off: After turning off the unit by pressing ON/OFF
●
button, the complete unit will be off directly.
4
TURBO button
Under COOL or HEAT mode, press this button to turn to quick COOL or quick
HEAT mode. "
to exit turbo function and "
If start this function, the unit will run at super-high fan speed to cool or heat quickly
so that the ambient temp. approachs the preset temp. as soon as possible.
5
▲/ button
● Press "▲" or "
Holding "▲" or "
change quickly. On releasing button after setting is finished, temperature indica-
tor on indoor unit will change accordingly. (Temperature can't be adjusted under
).
Auto
" icon is displayed on remote controller. Press this button again
" icon will disappear.
" button once increase or decrease set temperature 1℃ (°F).
" button, 2s later, set temperature on remote controller will
13
), medium
" is