AFWFilters 5600 Series Installation Instructions Manual page 21

Cycle Step
1
Error
Regen
2
Failure
Memory
3
Error
Upper
UD
Drive Sync
What are all the settings in the MASTER programming for?
Below is a chart with a list of all options shown in the MASTER programming. Please note
that depending on your system you may not see all the options shown.
This is for reference only, do not use this chart to make any changes to your settings.
Changes should only be made as directed in the programming section or by one of our
Code Parameter
Display
DF
Format
VT Valve Type
Unexpected cycle
input
More than 99 days
since last regenera-
tion (7 on day of the
week setups)
Circuit board memo-
ry failure
Piston is syncing
SXT Master Programming Chart
support technicians.
Options
GAL
Ltr
dF1b
Fltr
dF2b
UFbd
UFtr
Othr
Page 21
Unplug the system and check to en-
sure all electrical connections and cam
switches are secure. Plug the unit back in
and check the master programming and
ensure valve type and system type are
correct for your system. Initiate a manual
regeneration and verify it progresses
through the steps correctly. If error reoc-
curs, contact us for support.
Perform a manual regeneration to reset
the error. Check your settings to ensure
the system is setup to regeneration auto-
matically. Check the meter to ensure it is
not stuck and that the gallons remaining
is counting down.
Perform a hard reset and go through
the master programming to update the
settings. If error occurs again contact us
for support
Common when changing programming
or if system looses power. System will
automatically recover from this state
Description
Gallons, with 12-hour AM/PM format
Liters, with 24-hour format
Downflow single backwash
Filter
Downflow double backwash
Upflow brine first
Upflow filter
Other