Powering On And Off; Led Indicators - Horizon Fitness MobileMesh Manual

We recommend setting the host computer to a static IP address of 10.223.1.1 and netmask
255.255.0.0. Note: any setting in the 10.223.x.x address space is ok for your host computer, as
long as it is not the same as one of the radios on your network.
For Windows 10, here is a guide:
windows-10
For Ubuntu, here is a guide:
ubuntu-18-10-cosmic-cuttlefish-linux
6. Load the web UI
a. Using a web browser, type the IP address of the radio in the address bar. If successful, the
Doodle Labs web UI will load. From the factory, the username is root and there is no password
set.
For in-depth setup and configuration options related to the internal radio, refer to the Doodle Labs
"Smart Radio -J Embedded" documentation:
library/technical-library-downloads/
7. From the factory, the radios are set to the following:
a. Mode: Mesh Point
b. SSID/Mesh ID: simpleconfig
c. Security Key (WPA2-PSK): DoodleSmartRadio
Therefore factory-default radios will form an ad-hoc mesh network between themselves. There are
many modes of operation for the radios, please consult the documentation linked above.

POWERING ON AND OFF

The power on, momentary depress the power button
To power off, push and hold the power button for several seconds until you see both LEDs turn off.

LED INDICATORS

The MobileMesh radio has two LED indicators, Battery (BATT) and STATUS. The function of each is explained
below:
https://www.hellotech.com/guide/for/how-to-set-static-ip-
https://linuxconfig.org/how-to-configure-static-ip-address-on-
https://doodlelabs.com/technologies/technical-