Table of Contents
Advertisement
FACTORY RESET
Radios released after November 2021 support the ability to do a factory reset via multiple presses of the power
button.
To do a factory reset:
1. Power on the radio, and wait for it to fully boot (1+ minute)
2. Press the power button in short presses 10 times without pausing. Pressing the button about once per
second is good timing.
3. After ~10 presses, the status LED will start to flash purple.
4. The radio will reset itself to factory settings and reboot. This process may take 3-5 minutes.
5. After 3-5 minutes, check that you can access the web UI at the expected IP address. The factory address is
equal to 10.223.x.y where x.y is the last four hexadecimal digits of the wireless MAC address converted to
decimal. For example, a MobileMesh with MAC 0x00:30:1A:4E:7A:B0 has the last four HEX digits 7AB0 and
so x.y is equal to 122.176 since 0x7A=122 and 0xB0=176. This full IP address in this case would be
10.223.122.176.
6. You will need to reload Horizon31-specific scripts which control the LED and GCS connectivity as these are
wiped in a factory reset. Refer to the section above
SPECIFICATIONS
RF:
Doodle Labs™ Extreme Smart Radio Inside
RF Output Power: 2 Watts (33 dBm) (2450 model, may vary by band)
Range: up to 20 km (ground to air, directional antennas)
Maximum Throughput: 100 Mbps (40 MHz Ch.)
ISM License Free Bands: 902-928 Mhz, 2400-2482 Mhz, 3500-3700 Mhz, 5725-5875 Mhz
Licensed Bands: 1350-1390 Mhz,1625-1725 Mhz, 1755-1850 Mhz, 2025-2110 Mhz, 2310-2390 Mhz, 2400-2500
Mhz, 4400-5000 Mhz, 4800-4940 Mhz, 5030-5091 Mhz, 5180-5240 Mhz, 5745-5825 Mhz, 5650-5925 Mhz
Management:
LuCI Web Interface, UCI command line interface and SNMP
GPS:
uBlox NEO-M8P-2 RTK GPS (optional)
Power:
Standard PRC-148 Twist Lock Lithium-Ion battery
Operating Time: 20 hours typical. May range from 6-50+ hours depending on transmit duty cycle.
Optional AC and DC power kits available
"Updating The
Firmware".
Advertisement
Table of Contents
