Panasonic Lumix DC-TZ91 Operating Instructions Manual page 190

[Peaking]
When you perform Manual Focus operation, this function automatically adds colour to the
portions of the image that are in Focus (portions on the screen with clear outlines).
●
When [Detect Level] in [SET] is set to [HIGH], portions to be highlighted are reduced, allowing you
to achieve a more precise focus.
●
Changing the [Detect Level] setting also changes the [Display Color] setting as follows.
[Detect Level]
[Display Color]
●
Each time [
[LOW]) → [
●
This function is not available in the following case:
• [Rough Monochrome] (Creative Control Mode)
[Histogram]
Enabling/disabling the histogram display.
When set to [ON], you can move the display position of the histogram by pressing
• Direct touch operation is also possible from the recording screen.
Displays distribution of brightness in picture – e.g.
if the graph peaks at the right, this means there are
several bright areas in the picture. A peak in the centre
represents correct brightness (correct exposure). This
can be used as a reference for exposure correction, etc.
●
When the histogram is not the same as that of the recorded picture under the following
conditions, histogram will be displayed in orange:
• During Exposure Compensation.
• When the flash fires.
• When the correct exposure is not achieved, such as when the lighting is low.
190
[HIGH]
[ ] (Light blue)
[ ] (Yellow)
[ ] (Yellow Green)
[ ] (Pink)
[ ] (White)
] in [ ] is touched, the setting is switched in order of [
] ([Detect Level]: [HIGH]) → [OFF].
Using Menu Functions
[LOW]
[ ] (Blue)
[ ] (Orange)
[ ] (Green)
[ ] (Red)
[ ] (Grey)
Dark ← OK → Bright
Menu list
→ [Custom]
] ([Detect Level]:
(Example)
DVQP1288
.