Sealey LED500SB Quick Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY
1.1. GENERAL
Ensure the torch is fully charged before initial use.
9
DO NOT turn the torch on when it is being charged.
8
DO NOT shine directly into your, other person's or an animal's eyes.
8
DO NOT allow children to use the torch.
8
DO NOT handle or move the torch whilst it is being charged.
8
DO NOT use the torch if you suspect that the battery, the torch casing or the cable is damaged. Consult your Sealey Stockist.
8
DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery,
8
subsequently recharge the battery at least once every six months of non-use.
1.2. BATTERY SAFETY
WARNING! To reduce the risk of burns or fire:
‰
DO NOT Attempt to open, dismantle, modify or service the battery pack.
8
DO NOT Crush, puncture, short external contacts or dispose of in fire or water.
8
DO NOT Expose to temperatures above 40°C or below - 10°C.
8
DO NOT Expose to direct sunlight for long periods of time.
8
DO NOT Expose to moisture.
8
WARNING! DO NOT place the torch face down while in use.
‰
Replace only with the battery pack designated for this product.
9
Recycle or dispose of used battery as stipulated by local regulation.
9
If the electrolyte in the cells gets on your skin, wash thoroughly with water. If it gets in your eyes, rinse thoroughly with cool water and
9
seek immediate medical attention.
2. INTRODUCTION
Side mounted push-button to switch between two brightness settings of 100 or 300 lumens. Press and hold button for 500 lumens super beam.
Features a magnet on the end, along with a metal belt clip on the back for hands-free operation. Micro USB charging port. Supplied with
charging lead.
3. SPECIFICATION
MODEL NO: ........................................................LED500SB
Battery: .................................................. 3.7V, 600mAh Li-ion
Charging Time: ...............................................................2.5hr
LED Type: ........................................................ 3W COB LED
Length: ......................................................................... 89mm
Lumen Output: ...................................................... 100-300lm
Operating Time: .................................... 1.5hr (high) 3hr (low)
3.1. The battery fitted to this light is considered to be a consumable item and its ability to accept charge will reduce over time. We will
warranty it against mechanical and electrical defect for a period of one year, this does not cover fair wear and tear. If the battery is not
properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances we will not replace the
battery even if it is less than one year old.
4. OPERATION
4.1. Press on/off switch (see fig.1 overleaf):
First press: High Beam 300 lumens, Second press: low beam 100 lumens, Third press: switches everything off.
4.2. Long press: 500 Lumen super beam.
5. CHARGING
5.1. Charge: Open the cover on the side of the mini light. Plug in a USB charger into a standard 100 V - 240 V AC socket. Plug the micro
USB plug to the micro USB socket. It takes about 2.5 hours to fully charge the battery.
© Jack Sealey Limited
3W COB LED ALUMINIUM MINI HAND TORCH
LED500SB
MODEL NO:
Original Language Version LED500SB Issue 2 (4) 12/11/21