Table of Contents
Advertisement
drop the load. See instruction 3 page 7.
5. Select the lifting point on the fork lift with care. It must be strong
enough to resist the lifting force without damaging the fork lift. It is
desirable to cradle the lifting point in the arm notch when
possible(See Fig.1-B).
6. Use only the serrated lifting
pad, or the notch at the end of
the lifting arm as the lifting
contact. Do not attempt to use
any other part of the HFJ-400
lack as a lifting contact point.
7. Raise a fork lift with the HFJ-400 only when:
a. The forks are in a lowered position
b. There is no load of any kind on the forks
c. There are no personnel on the jacks
8. If the fork lift truck is to be lifted, lowered and relifted, the following
procedure is to be followed.
a. Lift and lower in accordance with the instructions in this manual
b. Before using a second jack, make certain that the jack is
replaced in full accordance with the initial instructions in this
manual. (See Paragraph 4 of Operating Instructions)
www.dominga.lt/krautuvai mob. tel.: +370 686 61770 tel.: +370 5 2432146 el. paštas: pakrovejai@dominga.lt
7
Fig.5
Advertisement
Table of Contents
