75F SMART DAMPER Installation & Operation Instructions

|
APPLICATION
The 75F Smart Damper is to be used as part of the Dynamic Airflow Balancing™
solution. The Smart Damper is where you will feed the 24VAC power bus line
from your power supply. The Smart Damper will also power a Wireless Room
Module (WRM), Wireless Ceiling Module (WCM), or a Remote Temperature
Sensor (RTS) through the provided Damper Harness.
|
PRECAUTIONS

When installing multiple dampers in a zone only provide the 24VAC
power bus line to one of the two dampers. (A zone constitutes a WRM,
WCM, or RTS).

Failure to wire devices with the correct polarity when using a shared
transformer may result in damage to any device powered by the shared
transformer.

Disconnect power before installing. Never connect or disconnect wiring
with the power applied.

Do not run the low voltage wiring in any conduit with line voltage.

Be sure RPPT is accessible for wiring.
|
FEATURES

24VAC power pass-through

Modulation of airflow through the duct controlled by the 75F Dynamic
Airflow Balancing™ solution
|
SPECIFICATIONS
Smart Damper

Supply Voltage: 24VAC

Operating Environment: 41°F – 122°F

Dimensions: (H) 6"; Diameter 6, 8, 10, 12", or custom sizes

Enclosure: Metal sheath
|
MOUNTING
INSTALLATION & OPERATION INSTRUCTIONS
www.75f.io
SMART DAMPER | RADIAL
+1 (651) 998-4080