Table of Contents
Advertisement
Quick Links
ASSEMBLY INSTRUCTIONS FOR 9B9301 KWIK BENCH SHADE
1. Unpack all parts and check for damage that may have occurred during shipping. If damage has occurred,
notify Kwik Goal immediately. Lay out all parts. Remove all cardboard and packaging immediately. Wet or
damp packaging may damage contents.
2. Read through entire instruction before beginning assembly and installation.
Shade (1)
Shade Rod
Frame Assembly (2)
Rod Assembly
Tube (4)
Tube Clamp
Assembly (8)
Carry Bag (1)
In slight wind, Kwik Bench Shade will cause assembled unit to overturn without any person or weight on Kwik Bench.
In windy conditions this unit could be damaged, come apart, or cause injury
Center Shade Tension Rod (1)
***CAUTION***
140 Pacific Drive Quakertown, PA 18951
800-531-4252 Kwikgoal.com
©
2019 Rev 2020 Kwik Goal Ltd.
End Shade Tension Rod (2)
Assembly Tools
Phillips Screwdriver
P1
Kwik Bench
(NOT Supplied)
NZ447 Rev. 04/16/20
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for KWIK GOAL 9B9301
Summary of Contents for KWIK GOAL 9B9301
- Page 1 ASSEMBLY INSTRUCTIONS FOR 9B9301 KWIK BENCH SHADE 1. Unpack all parts and check for damage that may have occurred during shipping. If damage has occurred, notify Kwik Goal immediately. Lay out all parts. Remove all cardboard and packaging immediately. Wet or damp packaging may damage contents.
- Page 2 3. Starting at one location, attach shade tube and tube clamp assembly to Kwik Bench as shown. (Not Supplied) Note: Make sure the open end of shade tube is at the top. Kwik Bench (NOT Supplied) Corners Corners Tube Clamp Assembly Kwik Bench Clamp Nut Side Open End...
- Page 3 6. Assemble shade rod frame assembly. Shade Rod Frame Assembled Shade Rod Frame Assembly 7. Starting at one end of shade insert one shade rod frame assembly into shade pocket as shown. Shade Start 8. Insert the second shade rod frame assembly into shade pocket. Shade Start ***CAUTION***...
- Page 4 9. With shade and shade rod assemblies installed, lift shade over Kwik Bench with Kwik Goal logos toward the front. Insert ends of shade rod assemblies into shade tubes at all 4 locations. Kwik Goal Logo Shade Rod Assembly Shade Rod Assembly...
- Page 5 11. Insert end shade tension rods into shade pockets at each end as shown and secure shade to tension rod with velcro tab. End shade Tension Rod Velcro Tab End Shade Tension Rod 12. Insert center shade tension rod into shade pockets at each end as shown and secure to tension rod with velcro tab.
- Page 6 13. Attach shade center strap on to the back at the center of Kwik Bench at location shown and pull strap snug. Do not over pull, too much tension could cause damage to shade. Rear View Rear View Shade Center Strap 14.
Need help?
Do you have a question about the 9B9301 and is the answer not in the manual?
Questions and answers