Table of Contents
Advertisement
5
Disassembly - Assembly
Disassembly: (see Spare Parts Drawing)
CAUTION
Prior to disassembly, disconnect equipment from air
supply in order to avoid the unintentional start of the
tool which may result in hand injuries!
Only experienced maintenance personnel may
assemble or disassemble this equipment.
After repair or maintenance, verify that equipment runs to specification!
Principally, use only DEPRAG original spare parts. Otherwise, a reduction
in equipment power-output and an increased maintenance-requirement
occurs. If NON-DEPRAG parts are installed, DEPRAG is justified to void
any existing warranty and liability obligations.
ATTENTION
Never clamp motor housing into a vice, without the usage of the
protective chucking jaws, since damage to motor-housing and
internal parts is unavoidable.
ATTENTION
Motor- and gearing parts may be damaged if dropped!
For disassembly proceed in the sequence described below:
1.
Disconnect screwdriver spindle from air supply.
2.
Unscrew the spring sleeve (Accessories - Optional Equipment) (left-hand
thread).
3.
Unscrew clutch bearing 335691 (AF 14, left-hand thread).
4.
Take out clutch 337310 D / 347227 D complete.
5.
Unscrew slide connector 821431 (AF 8, right-hand thread) and pull out
guide bolt 328493.
6.
Clamp motor housing 323000 / 335690 by means of the chucking jaws
461500 into a vice.
7.
Unscrew air inlet 326501 F complete at threaded fitting 324974 (AF 17,
right-hand thread).
8.
Insert allen key AF 6 (Part No. 800449) into the hex of the gear support
or spindle and push the motor- and gearing parts out of the motor hous-
ing in direction of the air inlet.
16
Advertisement
Table of Contents
