Table of Contents
Advertisement
receive data indication. It may be easier to align
ID A and ID B with 4520 powered off. The 4520
initiates the transmit/receive sequence, so the LED
will not flash on IDA through IDG until the 4520
is powered on.
USING SPARE T-LINKS
T-Link 3.0 identifier codes are preset at
the factory. Using an external Reconfig Jumper
provided with the backup T-link 3.0 unit, a T-Link
3.0's ID code can be changed enabling a single
backup unit to replace any unit with the same
optimizer code. To temporarily change the ID
code of a T-Link 3.0 unit, power the unit off.
Select the Reconfig Jumper with the desired ID
code and install into the T-Port of the T-Link 3.0
unit to be reconfigured. Power on the T-Link 3.0
unit. The green LED will flash three short times to
confirm the T-Link 3.0 unit has been reconfigured
Align Status
Solid RED - Not aligned
Power
Blink RED/GREEN - Power ON
RF Receive Status
Blink GREEN - Receive
Blink RED - Transmit
Figure 1 - T-Link 3.0 power and external connections
RaceAmerica 5840 T-Link 3.0 Wireless
to the new ID code. Unplug the Reconfig Jumper
and connect any cables to the T-Link 3.0 unit for
normal use. Do not power off the T-Link 3.0
unit after a new ID code has been assigned. The
change of ID is temporary. When the T-Link 3.0
unit is powered off, the ID code will revert back to
the preset ID shown on the bottom of the T-Link
3.0 unit.
BATTERY CHARGE
Charge the batteries using any USB battrey
charger. A PC USB port will charge but is a low
power output device and will not charge the T-Link
3.0 to full charge. All functional electronics are
disabled during battery recharge to avoid damage.
Typically full battery charging will take up to 6-8
hours if fully discharged. The charger indicator
LED will turn from red to yellow to green when
charging is complete.
Optimizer Code
e.g. C305
ID Code
e.g. 'C'
5
Advertisement
Table of Contents
