Cleaning, Maintenance And Repair; Preparing Charger For Use; Preparing The Charger For Use; Connecting And Disconnecting Battery - Stihl SL 100 Instruction Manual

5 Preparing Charger for Use

4.10 Cleaning, Maintenance and Repair

WARNING
￭ Harsh detergents, cleaning with a water jet or sharp
objects can damage the charger. If the charger is not
cleaned correctly, components may no longer function
properly or safety devices may be rendered inoperative.
They may cause serious injury to persons.
► Clean the charger as described in this User Manual.
￭ If the charger is not serviced or repaired correctly,
components may no longer function properly or safety
devices may be rendered inoperative. This may result in
serous or fatal injury to people.
► Do not attempt to service or repair the charger.
￭ If the connecting cable is faulty or damaged:
► Have the connecting cable replaced by a STIHL dealer.
5 Preparing Charger for Use
5.1

Preparing the Charger for Use

The following steps must be performed before commencing
work:
► Make sure the charger is in a safe condition, @ 4.5.
► Clean the charger, @ 10.
► Fitting the adapter, @ 6.1.
► If you cannot carry out this work: Do not use the charger.
0458-900-9921-A

6 Connecting and Disconnecting Battery

6.1

Connecting the battery

2
3
1
► Attach the adapter (2,3 or 4) at the charger (5).
► Connect the battery (1) to the adapter (2, 3 or 4).
6.2

Disconnecting the battery

► Disconnect the battery from the adapter.

7 Charging the Battery, LEDs

7.1

Charging the battery

The charging time depends on various factors, e.g. the
battery temperature or the ambient temperature. For
optimum performance, observe the recommended
temperature ranges, @ 13.3
When the power plug is plugged into a power outlet and the
battery is connected to the charger, charging starts
automatically. The charger switches off automatically when
the battery is fully charged.
The battery and the charger warm up during charging.
English
5
4
21