downward movement of the mechanism. The cover cannot be closed with the lock bar in place
due to the length of the handle.
Under certain conditions, it may be difficult to remove the lock bar if it is under pressure.
It may be necessary to use a 5/16" wrench on the brake end of the motor hex to relieve the
pressure of the lock bar against the reaction pin.
Refer to the following illustrations.
SIG-QG-21-01
Version: A
THE LOCK BAR IS MARKED WITH A "KEEP UP" DESIGNATION
ON ONE SIDE AND A "KEEP DOWN" DESIGNATION ON THE
OPPOSITE SIDE.
TO ACHIEVE THE DESIRED FUNCTIONALITY, MAKE SURE THE
KEEP UP OR KEEP DOWN MARKINGS ARE FACING TOWARD
THE MOTOR WHEN BEING INSTALLED AND NOT TOWARD THE
EXTERIOR OF THE GATE MECHANISM.
APPLY MINIMAL FORCE IN THE PROPER DIRECTION TO AVOID
DAMAGE TO THE DRIVE TRAIN.
CAUTION
CAUTION
2-5
ENTRANCE GATE
NOVEMBER 2021