Table of Contents
Advertisement
KOBE
I N D U S T R I A L
POWER TOOLS
You have purchased a quality product that is designed for high performance and long service life. If
correct use, safety and maintenance procedures are observed this machine will last for many years.
KOBE INDUSTRIAL POWER TOOLS have been specifically designed to help you work
SAFELY and EFFICIENTLY. Your care and good judgement are the best protection against injury, but
always ensure that the appropriate safety equipment is worn. All possible hazards cannot be covered here,
but the most important ones have been highlighted..
• Always adhere to the processes and safety
warnings, which are stated in the instruction
manual.
GENERAL OPERATING HAZARDS
• Always ensure the mains power supply
corresponds to the power rating on the
specification label on the machine.
• Always plug the battery charger into an
appropriate outlet that is properly installed and
grounded in accordance with all local codes
and ordinances. Check with a qualified
electrician if you are in doubt as to whether the
outlet is properly grounded.
• Always ensure the maintenance of electrical
components is carried out by a suitably
qualified person.
• Never allow routine to lead to mistakes.
• Never operate if any parts are missing or
damaged.
• Never allow untrained persons to operate
the tool.
WORKPLACE HAZARDS
• Always ensure your working area is clean
and well lit.
• When working at height make sure that the
tool is safely secured and be aware of objects
falling below. Make sure that no persons are
working directly below the working area.
• Do not operate in explosive atmosphere, for
instance extreme dust, gases and liquids.
• Keep children and bystanders away while
operating the tool. Distractions can cause you
to lose control.
• Always ensure all users are physically able
and competent to handle the size and weight
of items/components being drilled and have
received appropriate training to perform
the task.
• Never run the tool in areas exposed to water
or in damp conditions.
PERSONAL PROTECTION
• Always wear approved eye protection during
operation. Use safety glasses or goggles
which conform to BSEN136 or CE equivalent
that provide protection from the front and side.
2
SAFETY INSTRUCTIONS
The operator of the power tool is responsible
for following accepted eye, face, respiratory,
hearing and body protection.
• Always ensure that all long hair and loose
clothing, ties, scarves, jewellery, etc., are
secured or removed.
• Always consult a doctor if numbness, tingling,
pain or whitening of the skin occurs. Repetitive
work motions, awkward positions and exposure
to vibration can cause
"Repetitive Strain Injuries".
• When operating the tool stay alert and use
common sense, especially when it comes to
working at height. Be aware of what's
below you.
• Do not overreach. Keep a proper balance and
footing at all times.
• Remove any adjusting key or wrench before
turning the power tool on.
• If devices are provided for the collection of
dust, ensure these are connected and
properly used.
• Do not use the tool if under the influence of
alcohol, drugs or medication.
SPECIFIC SAFETY INSTRUCTIONS
• Do not force the power tool. Use the correct
power tool for your application. The correct
power tool will do the job better and safer at
the rate for which it was designed.
• Do not use the power tool if the switch does not
turn it on and off. Any power tool that cannot
be controlled with the switch is dangerous and
must be repaired.
• Store idle power tools out of the reach of
children and do not allow persons unfamiliar
with the power tool or these instructions
to operate the power tool. Power tools are
dangerous in the hands of untrained users.
• Maintain power tools. Check for misalignment
or binding of moving parts,breakage of parts
and any other condition that may affect the
power tools operation. If damaged,have the
power tool repaired before use. Many accidents
are caused by poorly maintained power tools.
Advertisement
Table of Contents
