Troubleshooting - Whirlpool WTW4810EW Use And Care Manual

Top-loading washer
Table of Contents

Advertisement

Available languages

Available languages

REINSTALLING/USING WASHER AGAIN
To reinstall washer after non-use, vacation, winter storage,
or moving:
1. Refer to "Installation Instructions" to locate, level, and
connect washer.
2. Before using again, run washer through the following
recommended procedure:
To use washer again:
1. Flush water pipes and hoses. Reconnect water inlet hoses.
Turn on both water faucets.

Troubleshooting

First try the solutions suggested here or visit our website at www.whirlpool.com/product_help -
If you experience
Vibration or Off-Balance
Check the following for
proper installation or
see "Using Your
Washer" section.
Noises
Clicking or metallic
noises
Gurgling or humming
Humming
Whirring
In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.
Possible Causes
Feet may not be in contact with the
floor and locked.
Washer may not be level.
Load could be unbalanced.
Objects caught in washer drain
system.
Washer may be draining water.
Load sensing may be occurring.
Basket deceleration may be
occurring.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
re, or electrical shock.
2. Plug in washer or reconnect power.
3. Run washer through Bulky Items/Sheets cycle to clean
washer and remove antifreeze, if used. Use half the
manufacturer's recommended amount of detergent for a
medium-size load.
Front and rear feet must be in firm contact with floor, and
washer must be level to operate properly.
Check floor for flexing or sagging. If flooring is uneven, a 3/4"
(19 mm) piece of plywood under your washer will reduce sound.
See "Level the Washer" in Installation Instructions.
Load dry items in loose heaps evenly around basket wall.
Adding wet items to washer or adding more water to basket
could unbalance washer.
Wash smaller loads to reduce imbalance.
Do not tightly pack. Avoid washing single items.
Use Bulky Items/Sheets cycle for oversized, non-absorbent
items such as jackets and small comforters. See "Cycle Guide".
See "Cycle Guide" and "Using Your Washer" in this Use and
Care Guide.
Empty pockets before washing. Loose items such as coins
could fall between basket and tub or may block pump.
It may be necessary to call for service to remove items.
It is normal to hear metal items on clothing such as metal snaps,
buckles, or zippers touch against the basket.
It is normal to hear the pump making a continuous humming
sound with periodic gurgling or surging as final amounts of
water are removed during the Drain & Spin cycles.
You may hear the hum of the sensing spins after you have
started the washer. This is normal.
You may hear the whirring sound of the basket decelerating.
This is normal.
Solution
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents