Table of Contents
Advertisement
5 . Add detergent
Pull out the detergent dispenser and add
detergent (and additives/softener) into the relative
compartments as described in section "DETERGENT
DISPENSER" . Observe the dosing recommendations
on the detergent pack .
Correct dosing of detergent / additives is important, because:
• it optimizes the cleaning result
• it avoids irritating residues of surplus detergent in your
laundry
• it saves money by avoiding waste of surplus detergent
• it protects the washing machine by avoiding
calcification of components
• it respects the environment by avoiding unnecessary
environmental burden .
6 . Delaying the start of a programme
• To set a programme to start at a later time, see the
section "OPTIONS/ START DELAY"
7 . Start programme
• Press the "Start/Pause"
illuminates, the door locks and the "Door locked"
indicator lights up .
• To avoid overflow, do not open the detergent
dispenser during a running programme anymore .
• The remaining programme duration can vary . Factors
like unbalance in the wash load, or foam formation, can
have an effect on the programme duration .
8 . Change the settings of a running programme, if
needed
You can still change the settings while a programme is
running . The changes will be applied, provided the respective
programme phase has not finished yet .
To change the settings of a running programme:
• Press "Start/Pause"
on pause .
• Change your settings .
• Press "Start/Pause"
programme .
If you have changed the programme, do not add detergent
for the new programme .
To prevent that a running programme is changed by accident
(for instance by children), use the "Key lock"
"FUNCTIONS") .
Pause a running programme and open the door, if
needed
• Press "Start/Pause"
• Provided water level or temperature is not too high,
the "Door locked"
open the door, for example to add more laundry, or to
remove laundry which was loaded by mistake .
• Press "Start/Pause"
programme .
9 . Cancelling a running programme, if needed
• Press and hold the "ON/OFF"
washing machine stops .
• If the water level and temperature are low enough, the
door unlocks and may be opened .
• The door remains locked if there is water in the drum .
To unlock the door, switch the washing machine on,
select the "Spin & Drain"
spin option off by setting the spin speed to "0" .
• The water is emptied and the door unlocks at the end
of the programme .
10
. The relative indicator lamp
to put the running programme
again to continue the
(see section
to pause a running programme .
indicator light turns off . You can
to proceed with the
button until the
programme and turn the
10 . Switch off the washing machine after programme End
• At the end of the cycle, the message "END" is shown on
the display .
• The door can only be opened when the symbol "Door
locked"
light turns off .
• Check that the "Door locked"
open the door and take out the laundry .
• Press "ON/OFF"
To save energy, if the washing machine is not switched
off manually with the button, it turns off automatically
approximately 30 minutes after the end of the programme .
Leave the door ajar to let the interior of the washing
machine to dry .
User manual
indicator is off, then
to switch the washing machine off .
Advertisement
Table of Contents
