Table of Contents
Advertisement
4
Please fix remote controller upper part into
the setup board attached to the surface of
the wall, as the picture below, and then,
connect with setup board by pressing
lower part.
- Please connect not to make a gap at the
remote controller and setup board's
upper and lower, right and left part.
<Connecting order>
Wall
Side
When separating remote controller from
setup board, as the picture below, after
inserting into the lower separating hole
using screw driver and then, spinning
clockwise, remote controller is separated.
- There are two separating holes. Please
individually separate one at a time.
- Please be careful not to damage the
inside components when separating.
<Separating order>
Wall
Side
Wall
Side
Wall
Side
INSTALLATION OF UNIT
17
Advertisement
Table of Contents
