OLYS STC-LED-V2.0 Series User Manual

Description of Functions
1. The charge controller adjusts itself automatically to 12V or 24V system voltage
2. LED Power： 12V system:Max.30W, 24V system： Max.60W
3. Build-in LED driver, Efficiency>95%
4. 4 periods work mode. Any adjustable power can be 10-90%.
5. Digital display, simple operation
6. Infrared remote control
7. Low voltage disconnect regulated by state of charge or voltage.
8. Complete electronic protection,it protects the battery from being overcharge by the solar array and from
being deep discharged by the loads. It can antomatic adaptation to the ambient temperature.
9. PCB board using moistureproof processing.
Attentions
The charge regulator is intended for use in photovoltaic systems with 12V or 24V nominal voltages, It shall be used
with vented or sealed (VRLA) lead acid batteries only.
Safety Recommendations:
1.Batteries store a large amount of energy. Never short circuit a battery under all circumstances. We recommend
to connect a fuse(30A) between battery and controller.
2.Batteries can produce flammable gases. Avoid making sparks, using fire or any naked flame. Make sure that the battery
room is ventilated.
3.Avoid touching or short circuiting wires or terminals. Be aware that the voltages on specific terminals or wires can
be up to double the battery voltage. Use isolated tools. Stand on dry ground and keep your hands dry.
Installation
82.4
104.4
93.4
104.4
（安装尺寸）
Solar Charge Controller
with Build-in LED driver
USER MANUAL
STC-LED-V2.0 Series
Thank you very much for buying our product
thoroughly before using the prouuct
Note：
1. Screws specifications M3 × 10 (since the attack)
2. Make sure that heat-location around other objects
were not blocke
Please read
,