Installation Requirements; Tools And Parts - Whirlpool WCG52424AS Installation Instructions Manual

WARNING: If the information in this manual is not followed exactly, a fire or explosion
may result causing property damage, personal injury or death.
– Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this
or any other appliance.
– WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electrical switch.
•
Do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's
instructions.
•
If you cannot reach your gas supplier, call the fire department.
– Installation and service must be performed by a qualified installer, service agency or
the gas supplier.
WARNING: Gas leaks cannot always be detected by smell.
Gas suppliers recommend that you use a gas detector approved by UL or CSA.
For more information, contact your gas supplier.
If a gas leak is detected, follow the "What to do if you smell gas" instructions.
IMPORTANT: Do not install a ventilation system that blows air downward toward this gas cooking appliance. This type of
ventilation system may cause ignition and combustion problems with this gas cooking appliance resulting in personal injury or
unintended operation.
In the State of Massachusetts, the following installation instructions apply:
Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by
I
the State of Massachusetts.
If using a ball valve, it shall be a T-handle type.
I
A flexible gas connector, when used, must not exceed 3 feet.
I
Gather the required tools and parts before starting installation.
Tools needed
Tape measure
■
Flat-blade screwdriver
■
/ " combination wrench
15
■
16
Pipe wrench
■
Pliers
■
Level
■
Phillips screwdriver
■
Marker or pencil
■
Pipe-joint compound resistant to LP gas
■
Noncorrosive leak-detection solution
■
2

INSTALLATION REQUIREMENTS

Tools and Parts

Parts supplied
Gas pressure regulator
■
Burner grates (2 or 4 depending on model)
■
Burner caps (4)
■
Clamping brackets (4)
■
1" (2.5 cm) clamping screws (4)
■
Parts needed
Check local codes and consult gas supplier. Check existing gas
supply and electrical supply. See "Electrical Requirements" and
"Gas Supply Requirements" sections.