Rowenta IS9100D1 Manual page 5

1103907038 IS9000 D1_110x220 25/06/10 11:28 Page5
• Depending on the model the steam amount can be set
to the desired level with the variable steam control.*
• The unit will produce steam in 60 seconds, when in max
position of variable steam control.
• Put garment onto the hanger head. Grasp the steam
head with the steam vents pointing away from you.
Start steaming by touching material lightly with stea-
ming head and moving in an up/down vertical motion.
Beginning at the top of the garment move in a down-
ward direction.
• During use, the hose may make a gurgling noise. This is
a normal occurrence due to condensation. If you hear
the gurgling noise, hold the hose up to direct the
condensation back into the appliance.
Warning: Do not allow the steamer to run dry.
Warning: Never use the steamer more than 3 hours.
Warning: Do not bend the steam hose during use or storage.
ccessories
Before using an accessory, check the manufacturer
recommendations.
It is also recommend that you carry out a test on part of
the fabric which cannot be seen.
Upholstery brush*
The upholstery brush is used to aid steam penetration
into difficult, heavy fabrics, for faster results.
Be sure unit is unplugged and completely cool before
attaching accesories.
• ttach the upholstery brush to the steam head by lining
up the bottom of the brush with the bottom of the steam
head. Gently push the top of the brush onto the steam
head until it clicks .
• G ently brush the area to be steamed with the grain or
nap of the fabric.
• Remove the upholstery brush once the unit is unplugged
and completely cooled down. Remove it by pressing on
the tab on top of the brush while pulling it forward.
Fabric brush*
The fabric brush opens the weave of the fabrics for better
steam penetration.
Be sure unit is unplugged and completely cool before
attaching accesories.
• ttach the fabric brush to the steam head by lining up
the bottom of the brush with the bottom of the steam
head. Gently push the top of the brush onto the steam
head until it clicks into place.
• Gently brush the area to be steamed with the grain or
nap of the fabric.
• Remove the fabric brush once unit is unplugged and
completely cool. Remove it by pressing on the release
tab on top of brush while pulling it forward.
Crease attachment*
• Gently push the crease attachment into place on the
steam head.
• Push on the handle to open the crease attachment .
• Place the garment between the crease attachment and
steam head.
• Release the handle.
• Starting at the top of the garment, move the crease
attachment in a downwards motion.
• Once unit is unplugged and completely cooled down,
remove the crease attachment by sliding it off of the
steam head.
* epending on the model: these accessories are specific to certain models or available as an option.
lways steam in a vertical position.
(depending on model)
5
EN
E
FR
NL
IT
ES
PT
SV
EL
TR
RU
UK
PL