Table of Contents
Advertisement
Malfunction
Rinse aid refill
indicator lights up.
Rinse aid refill
indicator is not lit.
Malfunctions
Malfunction
There will remain after the
program water in the
appliance.
Device cannot be
switched on or operated.
The device does not start.
Program starts
automatically.
Device hangs in a
program or cuts out.
Cause
Rinse aid is missing.
Water softening is
switched off.
Cause
Sieve system or space below
the sieve is clogged.
Program has not yet
ended.
Device functions
have failed.
Fuse of the house
installation is not OK.
Power cord is not
connected.
Appliance door is not
completely closed.
The program has not
ended.
Appliance door is not
completely closed.
Troubleshooting NL
Troubleshooting
Fill the "rinse agent"
1.
→
Page 24 Bee.
Set the amount of rinse aid.
2.
→ "Amount of rinse aid
set", page 24
Amount of rinse aid in
▶
set.
Troubleshooting
Clean the "seven" → Page 36.
1.
2.
Clean the "drain pump"
→
Page 50.
▶
Wait for the end of the program
or cancel the program with Reset
off.
→ "Abort program",
▶
Page 32
Disconnect the appliance
1.
from the mains or switch off
the fuse.
Wait at least 2 minutes.
2.
Connect the device to
3.
the mains.
Switch on the device.
4.
▶ Check the fuse of the house
installation.
Check that the socket is
1.
working.
2.
Check whether the connecting cable is
properly connected to the mains
socket and to the rear of the
appliance.
▶
Close the appliance door.
→ "Abort program",
▶
Page 32
▶
Close the appliance door.
47
Advertisement
Table of Contents
