Advertisement
WIRING DIAGRAM
1. FEATURES
Power supply and lights to be wired to the TH708-12 light controller as follows:
!
CONNECTING THE INCORRECT POWER SUPPLY TO THE LIGHT
CONTROLLER WILL DAMAGE THE UNIT AND VOID THE WARRANTY
1
WIRING PINS 1-4
Pin 1 = 12v dc input
Pin 2 = Ground
Pin 3 = DC out to lights
Pin 4 = DC out to lights
LEARNING REMOTES
1.
Connect the power supply
and Lights to the controller as
per wiring diagram. Turn the
power on (unit will beep).
3.
Using the back of the
remote or a magnet, swipe
against the 'SWIPE HERE' mark
on the controller. The control-
ler will beep once.
.
DELETE ALL CONTROLLERS
1.
Turn o the power to the controller.
3.
The unit will beep for
around 10 seconds, then will
give you two more short
beeps (do not remove until
two beeps are heard).
2
2.
Select the
channel on the
remote that you
wish the light to
be controlled
with.
4.
Press the open button on the
remote control and the controller
will give you a few short beeps,
indicating it has memorised the
remote control.
2.
Using the back of the remote or
magnet, hold near the 'SWIPE HERE'
mark and simultaniously turn on
the power.
.
10sec
Advertisement
