Advertisement
3
The pulsator rotates for
8 seconds to detect the
laundry load.
Then the WATER
LEVEL will be shown
and water will be
supplied.
4
4
4
4
Close the lid
5
Water will be topped
When the wash
up for 2 minutes
program ends, the
after the start of the
buzzer will ring for
wash to supplement
10 seconds before
the water the
the Power goes off
laundry has
automatically.
absorbed.
6
6
6
6
Finish
6
If water is already in the tub, or
putting wet laundry into the tub
before starting will increase the
WATER LEVEL.
With lightweight bulky loads,
WATER LEVEL will be automatically
set to low.
Changes to Water Temperature
(refer to page 15) and wash level are
possible during operation.
(refer to the 'start/pause' button
function on page 15)
7
Before starting to wash, make sure that
7
the laundry is washable.
Washing with HOT water may
damage the laundry.
Ensure that the load is under 2kg.
When setting the WATER LEVEL
7
manually, do not set to Medium or
lower to prevent damage to laundry.
Washing with HOT water may
damage the laundry .
Ensure that the load is under 2kg.
In order to avoid damage to laundry,
the spin cycle may appear slow. This
also avoids wrinkles and clothing may
still contain some water. This is
normal.
7
Caution & Note
17
Advertisement
