Caroma QUIET FLOW Installation Instructions

�
������������ ������������
���� ����
��
���� ���
���� ���
����
�������� ����
� ����
IMPORTANT:- It is critical the 31mm minimum
air-separation from the top of the overflow to the
critical level mark on the inlet valve is maintained.
�
Insert Quietflow valve into cistern & secure in
place using nut provided.
�
�������� ����� � ��
�������� �����
����� ����� � ��
���� �� �������
� ����� ����
���� ���
���� ���
Using a ruler, measure the distance from the
base of the cistern to the WL mark on the back
of the cistern.
�
Flush the water supply line before connecting to
stop cock & turn mains water on. Check water
level height is correct and that there are no
leaks.
*
This Inlet Valve must be installed in accordance with AS/NZS 3500.1
� �
��
�������
Remove clip on Slide valve body
Quietflow valve and up/down until the WL
twist body to release mark on valve body
from it's current set corresponds to the
height. height measured in
step 1.
�
For further water level adjustment, ensure mains water is turned off.
Repeat steps 2-4 until the desired water level is achieved.
Installation Instructions
�
��
��
�������
Twist & lock valve
body back into place
before replacing clip.