Skoda Superb 2005 Owner's Manual page 255

254 Breakdown assistance
– Screw in the wheel bolts and tighten them slightly with the aid
of the hexagon socket.
– Unscrew the assembly pin and screw in the remaining wheel
bolt also slightly.
The wheel bolts must be clean and must turn easily.
The hexagon socket in the handle of the screwdriver makes it simpler to
fit on the wheel bolts. The reversible blade should be pulled out for this
step.
When fitting on unidirectional tyres, ensure that the tyres rotate in the
correct direction ⇒ page 241.
Note
Do not use the hexagon socket in the handle of the screwdriver for slack-
ening or tightening the wheel bolts.
Securing wheels against being stolen
You need a special adapter for slackening the safety
wheel bolts.
– Pull off the full wheel trim/cap from the wheel hub or cap from
the safety wheel bolt.
A
– Insert the adapter with its toothed side fully into the inner
B
toothing of the safety wheel bolt
that only the outer hexagon is jutting out
– Insert the wheel wrench fully onto the adapter
– Slacken the wheel bolt, or tighten it firmly ⇒ page 240.
– Reinstall the full wheel trim/wheel cap after removing the
adapter or place the cap onto the safety wheel bolt.
Fig. 194 Safety wheel
bolt with adapter
A
right down in such a way
A
⇒ fig.
194.
A
.
B