PARTS LIST: Ref. Qty. Part Description Heater Assembly Wiring Harness Switched Power Extension Cup Mount Tripod Mount Nut Plate Hardware Kit Washer Phillips HD Screw Hex HD Nut Hex HD Bolt Self-Tapping Screw Velcro Tie SUGGESTED TOOLS: • Drill • 5/32”...
Page 3
WIRING HARNESS (02) DIAGRAM Note: Accessory connectors not used for this installation. Page 3 of 9...
INSTALLATION INSTRUCTIONS SWITCHED POWER HOOKUP • This step will vary depending on your vehicle RUN THE WIRING HARNESS model. Locate a switched power connection and connect using the Switched Power • Run the Wiring Harness (02) from the front Extension (03). This is commonly located on of the vehicle to the battery compartment.
Page 6
IF USING THE CUP MOUNT (04) Note: To install into an existing cup holder, use the • Cup Mount (04). Use the Tripod Mount (05) to install Depress locks on side of Cup Mount & rotate directly onto the dash. bottom to disengage teeth.
Page 7
OPERATING GUIDE BI-LEVEL VENT SYSTEM The Electric PTC Heater has four modes of The three center fins can be moved to adjust operation with a color-coded LED indicator. the air flow direction. Rotating the fins to their maximum upward position will partially close the front vent and send air out the side vents, towards the floor.
SAFETY MAINTENANCE Periodically check Electronic Eye lens for Only operate the heater while module is attached smudges or debris and gently wipe clean with a to its base and securely mounted in the vehicle. microfiber cloth. Contamination of the Electronic Do not block the heater air intake.
Page 9
1. During the first year from the original carton being returned to TSI Products/ retail purchase date, TSI Products/ Stratos Climate. Stratos Climate will, at its option, repair or replace defective components, 2. Attach, to the product itself, a tag including labor and cost of shipment to showing your name, address, phone original consumer.
Need help?
Do you have a question about the SCP7106 and is the answer not in the manual?
Questions and answers