Advertisement
Polaris RZR
P/N SCP8000
Before you begin, read these instructions TWICE and check to be sure
all parts and tools are accounted for. Please retain these installation
instructions for future reference and parts ordering information.
This Kit Includes:
Ref.
Qty.
A
1
B
1
C
1
D
16'
E
2
F
1
G
2
H
8'
I
1
J
3
K
8
L
1
M
2
N
2
O
4
P
4
Q
1
R
1
S
2
T
4
Part Description
Heater w/mounting bracket
3 Speed Fan Switch & Knob
Decal for Fan Switch
Heater Hose
Firewall hose Grommets
Lg Wiring Harness
Y-Connector 1"x1"x5/8"
Flex Hose
Defrost Vent
Square Vents
Flex Hose Clips
Vent Bracket
Screws
Nuts
Lg Hose Clamps
Sm Hose Clamps
Inner/Outer Star Washer
Locking Washer
Self-tapping Screws
Templates
Rev. 1 1215
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for STRATOS SCP8000
Summary of Contents for STRATOS SCP8000
- Page 1 Polaris RZR P/N SCP8000 Before you begin, read these instructions TWICE and check to be sure all parts and tools are accounted for. Please retain these installation instructions for future reference and parts ordering information. This Kit Includes: Ref. Qty.
- Page 2 Suggested Tools: Drill Hose Pliers Deburring tool or Sandpaper 1 3/8” Hole Saw Screw drivers Hot Knife Hose Cutter Voltage Meter/Test Light Wire Cutter Hot Engine coolant can cause severe burns. WARNING: Never open the cap on a hot radiator. Allow the engine to cool completely before beginning any work.
- Page 3 POLARIS RZR INSTALLATION INSTRUCTIONS Put the vehicle in park. Turn Key to “OFF” position and remove from the vehicle. Never work on a hot vehicle, as severe burns can occur. Remove Drivers seat. Disconnect the black negative battery cable from battery. Disconnect the red positive battery cable from battery.
- Page 4 14. Seat grommets (E) into holes of firewall. Make sure to position hoses so there are no kinks. 15. Route large wiring harness (F) through existing hole in firewall (Picture 3 shows existing hole) 10. Mark a spot on the radiator hose on the engine coolant return side.
- Page 5 21. Locate a position on the upper instrument panel to install the defrost vent (I). Secure the template (3) in place and cut the instrument panel along the dotted line. Be sure to check for clearance and obstructions before cutting. Place two flex hose clips (K) on the backside of the vent and install defrost vent.
- Page 6 30. Reconnect the battery. Do NOT Start Engine. 31. Locate the Terminal or Fuse Block. (Picture 13 is typical). The wiring harness (F) has 3 wires, a red power wire, a yellow ignition/accessory wire and a black ground wire. Using a Voltage meter or Test Light, with the ignition switch off, test the terminals in the terminal block.
Need help?
Do you have a question about the SCP8000 and is the answer not in the manual?
Questions and answers