Syslog; Cli Configuration - Tripp Lite NGI-S05C2POE4 Owner's Manual

Tx Utilization (bps)

7.5. Syslog

The syslog function records some of system information for debugging purpose. Each log
message recorded with one of these levels, Alert / Critical / Error / Warning / Notice /
Information. The syslog function can be enabled or disabled. The default setting is disabled.
The log message is recorded in the Switch file system. If the syslog server's IP address has
been configured, the Switch will send a copy to the syslog server.
The log message file is limited in 2000 entries. If the file is full, the oldest one will be replaced.
7.5.1.

CLI Configuration

Node Command
enable show syslog
enable show syslog level
<1-6>
enable show syslog server
enable configure terminal
configure syslog-server
(disable|enable)
configure syslog-server ipv4-ip
IPADDR
configure clear syslog
configure archive upload-syslog
<URL PATH>
Example:
L2SWITCH#configure terminal

L2SWITCH(config)#syslog-server ip 192.168.200.106

L2SWITCH(config)#syslog-server enable

The field display Tx utilization in bps.
The command displays all of log message recorded in
the Switch.
The command displays the log message with the level
recorded in the Switch.
The command displays the syslog server
configurations.
This command changes the node to configure node.
The command disables / enables the syslog function.
The command configures the syslog server's IP
address.
The command clears all of the syslog messages.
This command uploads the current syslog message to a
TFTP server.
Where <URL PATH> can be:
ftp://user:pass@192.168.1.1/file
http://192.168.1.1/file
tftp://192.168.1.1/file
120
Description