Homewhiz Function; Homewhiz Setup And User Account; Settings - Beko BDF1640AX User Manual

HOMEWHIZ FUNCTION

5 5 6
You can check your dishwasher and learn
about its status via your smart device with
the HomeWhiz function.
C
HomeWhiz only runs on a
frequency band of 2.4GHz.
C
You can use your machine via
your smart device while the
function is selected. You can
monitor your machine through
the application when the
function is not selected.
C
You can check the indicator on
the product to see if the function
is enabled or not.
If the function is disabled, the
HomeWhiz indicator will be off
or continuously flash at short
intervals. For example, when the
wireless connection setting is
off or the door of the machine is
open.
C
The function will be disabled
when the door of the
dishwasher is open or when
operations regarding On/Off are
performed on the machine. It
can be enabled again with the
remote control key.
The display when HomeWhiz is enabled.
40 /52 EN
HomeWhiz Setup and User
Account Settings
Install the HomeWhiz application from the
application store of your smart device to use
the WLAN function of your machine. Make
sure that your smart device is connected to
the internet to use the application.
If you are using the application for the first
time, complete the registration process with
your e-mail address on the application. Once
you've completed the registration process,
you can use all HomeWhiz supported
appliances in your house through this
account.
You can tap "Add/Remove Appliance"
under the "Appliances" section to see the
appliances paired with your account. You can
perform the user pairing processes of these
appliances from this page.
Initial setup
1 Tap "Add/Remove Appliance" section on
the HomeWhiz application.
2 Tap "Tap here to setup a new appliance".
3. When the machine is off, press the
on/off key and the remote control key
simultaneously to enter the settings
menu. Press the setting key to set the
product to "wireless connection setup".
4. Then, in the settings section of your
smart device, connect to "HomeWhiz
xxx-xxxx" network under the wireless
connection settings. Password of the
network can be seen on the HomeWhiz
application.
5. Connect your smart device to the
HomeWhiz network and return to
the HomeWhiz application. On the
application, you can see the dishwasher
you are adding. Tap Next to proceed to
the next step.
/