Table of Contents
Advertisement
1.3 Comb filter operation check
Adjustment preparation
(1) Receive the color bar signal at the regular tuning
point.
(2) Set the CONTRAST control to MAX and the other
controls to center.
Adjustment procedure
(1) Check line dots condition at border of each color A, B
as follows.
A
Check
A
and
line dots.
B
3D Y/C
Dots
A None
B None
1.4 Video Settings Check
1.4.1 Color Temperature Control Check
Adjustment preparation
(1) Receive the white raster signal.
(2) Set the video controls to normal conditions.
Adjustment procedure
(1) Select the Video mode using the
press Select button.
(2) Select Color Temperature option using the
buttons and press Select button.
(3) Select MEDIUM using
turn reddish slightly.
(4) Select STANDARD using
will turn more reddish.
(5) Select Black & White using
will turn more and more reddish.
(6) Select HIGH using
bluish.
BACK TO ADJUSTMENTS
A
A
B
buttons and
buttons and Picture will
buttons and Picture
buttons and Picture
buttons and Picture will turn
Important: High Voltage adjustment should
!
NOT be adjusted in field. This is
adjusted at factory using precise
loads
readjusted.
1.5
High Voltage Adjustment (should NOT be
readjusted in field).
Adjustment preparation
(1) Connect High Voltage meter to FBT High Voltage
output. Connect GND of High Voltage meter to CPT
GND or FBT GND.
(2) Check that High Voltage adjustment VR (RH17) is
set to mechanical center. (located behind FBT on
DEFLECTION PWB).
(3) Receive circle pattern signal.
(4) VIDEO control should be reset.
Adjustment procedure
(1) Adjust High Voltage to following spec. by turning VR
RH17 slowly. ADJ. SPEC = 31.7KV±0.2kV.
(2) After adjustment, fix VR RH17 with Silicone glue
(KE40RTV).
High Voltage Adjustment VR.
RH17
2. FINAL ASSEMBLY ADJUSTMENT
2.1 Cut Off Adjustment
Adjustment Preparation:
Adjustment preparation
1. Allow 20 minutes pre-heat run.
(1) Adjust screen VR's on Focus Pack fully
counterclockwise.
2. Set video conditions to factory presets.
(2) Adjust Focus VR's on Focus Pack fully
clockwise.
Adjustment Procedure:
(3) Set video conditions to factory preset.
1. Access the I2C Adjustment Mode
(4) The vertical incident illumination on the screen
1.1 Press the following buttons on the remote, in
should be 20 lux or less (room should be dark).
sequence: MENU, MENU, 8, SELECT.
(5) Pre-heat run time should be at least 20 min.
2. Select SERVICE from adjustment menu by
pressing the
collapse the vertical deflection.
3. Turn all screen (G2) controls to the full counter-
clockwise position.
28
and
should
NOT
DEFLECTION PWB.
button on the remote. This will
FOCUS PACK
CH 2
DP55
be
Advertisement
Table of Contents
