Cooking With The Automatic Programmes; Basic Settings - Bosch BFL553MS0B Instruction Manual

Programme no.
Defrost
P 01 Minced meat
P 02 Pieces of meat
Chicken, chicken
P 03
pieces
P 04 Bread

Cooking with the automatic programmes

With the 3 cooking programmes, you can cook rice,
potatoes or vegetables.
Notes
Ovenware
■
The food must be cooked in microwaveable
cookware with a lid. For rice, you should use a large,
deep dish.
Preparing food
■
Weigh out the food. You need to know the weight to
set the programme.
Rice:
Do not use boil-in-the-bag rice. Add the required
amount of water, as specified on the packaging. This
is usually two or three times the quantity of rice.
Potatoes:
For boiled potatoes, cut the fresh potatoes into
small, even-sized pieces. Add one tablespoon of
water for each 100 g boiled potatoes, and a little
salt.
Fresh vegetables:
Weigh out the fresh, trimmed vegetables. Cut the
vegetables into small, even-sized pieces. Add a tbsp
water for each 100 g vegetables.
Signal
■
While the programme is running, a signal sounds
after some time. Stir the food.
Resting time
■
Once the programme has finished, stir the food
again. You should leave it to stand for another
5 to 10 minutes until it reaches an even temperature.
The cooking result will depend on the quality and
consistency of the food.
Programme no.
Cooking
P 05 Rice
P 06 Potatoes
P 07 Vegetables
Weight range in kg
0.20 - 1.00
0.20 - 1.00
0.40 - 1.80
0.20 - 1.00
Weight range in kg
0.05 - 0.2
0.15 - 1.0
0.15 - 1.0
QBasic settings
Y our appliance has basic settings that you can change
B a s i c s e t t i n g s
to suit your needs.
Setting Options
Button tone
‚ Ž *
Œ
Demo mode
ƒ š"‹
* Factory setting (factory settings may vary depending on the appli-
ance model)
You can change the button tone on your appliance if
you wish.
Changing the button tone
The appliance must be switched off when you do this.
Press and hold the start and stop buttons at the
1.
same time for a couple of seconds.
‚ will appear in the display.
Touch the start button.
2.
Ž will start flashing in the display.
Turn the rotary selector to
3.
Touch the start button.
4.
The setting has been applied.
Touch the stop button.
5.
The button tone has been switched off.
You can change this setting at any time.

Basic settings

Switched on
Switched off
Button tone (will remain active for
the start and stop buttons)
The appliance is switched off. You
can use the buttons and the display,
but the buttons will not activate any
function on the appliance (i.e. the
microwave has no power). Demo
mode is mainly used by dealers.
Œ
.
en
13