AVS RM Series Install Manual

Thank you for choosing the AVS range of LCD monitors. Please ensure installation is carried out by a qualified technician.
IMPORTANT: Where wiring diagram shows an ACC connection the wire MUST be connected to ACC do not connect to ignition or constant
12v.
AVS RM43
WIRE COLOUR FUNCTION
RED (ACC) +12v ACC supply
BLACK Earth
YELLOW RCA AV2 camera input
WHITE RCA AV1 camera input
(RM43)
YELLOW RCA AV1 camera input
(RM50SM)
REAR BUTTON FUNCTION
TOP Adjust display brightness/contrast up
MIDDLE MENU – push to enter menu and scroll through functions –
BOTTOM Adjust display brightness/contrast display down
AVS RM SERIES LCD MONITORS – INSTALL GUIDE
October 2019
All connections to 12/24v should be appropriately fused.
General wiring schematic
CONNECT TO
Appropriately fused +12v switched ACC supply
Good earth source e.g. vehicle body/chassis
Reverse camera output. Monitor will auto switch to display this input when a signal is
detected e.g. when the car goes into reverse and powers on the camera. The display will
switch back to AV1 or turn off if there is no signal on AV1.
Camera output. Monitor will display AV1 until a signal is detected on AV2.
Camera output. Monitor will display AV1 until a signal is detected on AV2.
AVS RM50SM
brightness – contrast – saturation – language – mode - reset