Gigabyte GA-F2A88X-D3HP User Manual page 25

6) SATA3 0/1/2/3/4/5/6/7 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The AMD Chipset supports RAID
0, RAID 1, RAID 5, RAID 10, and JBOD. Refer to Chapter 3, "Configuring a RAID Set," for instructions on
configuring a RAID array.
To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Peripherals\SB SATA
Configuration," for more information.
7) CLR_CMOS (Clear CMOS Jumper)
Use this jumper to clear the BIOS configuration and reset the CMOS values to factory defaults. To clear
the CMOS values, use a metal object like a screwdriver to touch the two pins for a few seconds.
• Always turn off your computer before clearing the CMOS values.
• After system restart, go to BIOS Setup to load factory defaults (select Load Optimized Defaults) or
manually configure the BIOS settings (refer to Chapter 2, "BIOS Setup," for BIOS configurations).
6
7
1
7
1
7
1
1
1 3 5
0 2 4
Open: Normal
Short: Clear CMOS Values
- 25 -
DEBUG DEBUG
DEBUG
PORT PORT
PORT
DEBUG DEBUG DEBUG
PORT PORT PORT
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
7 5 RXN
6 RXP
7
7 GND
Hardware Installation