Related Manuals for SGS SWPT80
Summary of Contents for SGS SWPT80
- Page 1 SWPT80 PETROL TRASH WATER PUMP OWNER’S MANUAL FOR YOUR SAFETY PLEASE READ THESE INSTRUCTIONS CAREFULLY AND RETAIN THEM FOR FUTURE USE.
-
Page 2: Specification
WARNING SPECIFICATION Product Code SWPT80 1. ALWAYS ensure that the pump is properly positioned where Suction Port 80mm necessary to prevent it from moving during operation, and that Max Head the immediate area surrounding the pump is kept clear. Noise Emission 110 dB (Lwa) 2. -
Page 3: Before Use
NOTE: The unit is fitted with a low oil sensor which will stop the engine if the oil level drops below the safe level to avoid internal damage. Refer to troubleshooting section. WWW.SGS-ENGINEERING.COM PAGE 4 PAGE 5... -
Page 4: Starting The Engine
3. To start a cold engine, move the choke lever to the CLOSED 5. Turn the ignition switch to the ON position. position. To restart a warm engine, leave the choke lever in the OPEN position. WWW.SGS-ENGINEERING.COM PAGE 6 PAGE 7... -
Page 5: Setting The Engine Speed
After use, remove the pump drain plug, and drain the pump chamber. Remove the filler cap, and flush the pump chamber with clean, fresh water. Allow the water to drain from the pump chamber, then re-install the filler cap and drain plug. WWW.SGS-ENGINEERING.COM PAGE 8 PAGE 9... - Page 6 Refilling is necessary only if the pump has been drained or if the water has been lost. Never al- low the pump to run dry. 5. Properly fuelled and lubricated your pump will run without at- tention. WWW.SGS-ENGINEERING.COM PAGE 10 PAGE 11...
-
Page 7: Maintenance
In this location both the inlet and exhaust valves are away used oil with domestic refuse or flush down a sink or drain. closed which may prevent the engine from suffering internal corrosion during storage. Take it to your local waste disposal site. WWW.SGS-ENGINEERING.COM PAGE 12 PAGE 13... -
Page 8: Troubleshooting
Ensure there are no kinks in delivery hose. Engine speed too low. Increase engine speed. Damaged impeller. Renew impeller after dismantling pump. Air leaks through dam- Renew seal. aged seal. WWW.SGS-ENGINEERING.COM PAGE 14 PAGE 15... -
Page 9: Parts Diagram
902337 Pump cover 902338 Mechanical seal 902339 Hexangular hose joint 902340 Strainer 902341 Rubber feet 902291 Bolt M8X20 900393 Flange Nut M8 900520 Flange hd hex. bolt M8X20 902265 Gasoline engine 7.0hp 902294 Frame 902321 WWW.SGS-ENGINEERING.COM PAGE 16 PAGE 17... - Page 10 EC Declaration of Conformity This is an important document and should be retained SGS Engineering (UK) Ltd MANUFACTURER’S NAME: Water Pump TYPE OF EQUIPMENT: SWP50 / SWP80 / SWPT80 PART NUMBER: APPLICATION OF EC COUNCIL DIRECTIVES / STANDARD: 2006/42/EC Machinery directive 2004/108/EC...
Need help?
Do you have a question about the SWPT80 and is the answer not in the manual?
Questions and answers