Related Manuals for SGS SWP80
Summary of Contents for SGS SWP80
- Page 1 SWP80 PETROL WATER PUMP OWNER’S MANUAL FOR YOUR SAFETY PLEASE READ THESE INSTRUCTIONS CAREFULLY AND RETAIN THEM FOR FUTURE USE.
-
Page 2: Specification
WARNING SPECIFICATION Product Code SWP80 1. ALWAYS ensure that the pump is properly positioned where Suction Port 80mm necessary to prevent it from moving during operation, and that Max Head the immediate area surrounding the pump is kept clear. Noise Emission 111 dB (Lwa) 2. -
Page 3: Before Use
NOTE: The unit is fitted with a low oil sensor which will stop the engine if the oil level drops below the safe level to avoid internal damage. Refer to troubleshooting section. WWW.SGS-ENGINEERING.COM PAGE 4 PAGE 5... -
Page 4: Starting The Engine
3. To start a cold engine, move the choke lever to the CLOSED 5. Turn the ignition switch to the ON position. position. To restart a warm engine, leave the choke lever in the OPEN position. WWW.SGS-ENGINEERING.COM PAGE 6 PAGE 7... -
Page 5: Setting The Engine Speed
After use, remove the pump drain plug, and drain the pump chamber. Remove the filler cap, and flush the pump chamber with clean, fresh water. Allow the water to drain from the pump chamber, then re-install the filler cap and drain plug. WWW.SGS-ENGINEERING.COM PAGE 8 PAGE 9... - Page 6 “hydraulic shock”, which can dam- if no check valve is used in the discharge line. age the pump and/or the hose). 6. Properly fuelled and lubricated your pump will run without at- tention. WWW.SGS-ENGINEERING.COM PAGE 10 PAGE 11...
-
Page 7: Maintenance
In this location both the inlet and exhaust valves are away used oil with domestic refuse or flush down a sink or drain. closed which may prevent the engine from suffering internal corrosion during storage. Take it to your local waste disposal site. WWW.SGS-ENGINEERING.COM PAGE 12 PAGE 13... -
Page 8: Troubleshooting
Ensure there are no kinks in delivery hose. Engine speed too low. Increase engine speed. Damaged impeller. Renew impeller after dismantling pump. Air leaks through dam- Renew seal. aged seal. WWW.SGS-ENGINEERING.COM PAGE 14 PAGE 15... -
Page 9: Parts Diagram
902315 Flange hd hex. bolt M8X25 902285 Water intake seat 902317 Water intake Valve 902318 Water out rubber seal 902319 Water out pipe 902320 Bolt M8X20 900393 Rubber feet 902291 Frame 902321 Filter set 902324 WWW.SGS-ENGINEERING.COM PAGE 16 PAGE 17... - Page 10 SGS Engineering (UK) Ltd West Side Park Raynesway Derby, DE21 7AZ EC Declaration of Conformity This is an important document and should be retained SGS Engineering (UK) Ltd MANUFACTURER’S NAME: Water Pump TYPE OF EQUIPMENT: SWP50 / SWP80 PART NUMBER:...
Need help?
Do you have a question about the SWP80 and is the answer not in the manual?
Questions and answers