Advertisement
SPECIFICATIONS
Sample range
Latency
Range
THD+ Noise
Dynamic Range
Operating Band
Frequency response
Adjustable angle
TROUBLESHOOTING
Device cannot be powered on
and doesn't work.
Device can be powered on,
but cannot operate, with no
sound at all.
Strange noise while in use.
Device cannot be charged
properly.
How to connect to multiple
Receivers from one
Transmitter
24bit / 48KHz uncompressed digital transmission
<12 ms
≥100 feet outdoors, unobstructed
-98dB
>105dB(A) weighted
2.4GHz ISM Worldwide
20~20KHz, +1dB / -3dB
280°
If the devices are unused for a long time, or powered off
during low battery but not recharged for a long time,
the battery enters protection mode to preserve the
battery. Charge the battery to full before use.
Check whether the LED indicator is green. If the LED is
flashing, then the Transmitter and Receiver are to
paired yet. If the LED is red, charge the devices.
Noise can occur if there is quite strong electromagnetic
interference, or if the transmission distance is too far.
Try to shorten the transmission distance, and check
other devices in operation which may be transmitting
electromagnetic interference.
The lithium battery enters into protection if it's in low
battery for a long time. Ensure it is charging for over 10
minutes before turning on.
While pairing, turn on all Receivers and enter into
pairing status. Then, put the Transmitter into pairing
status. When the pairing is complete, it will be
connected to all of the Receivers.
Advertisement
