Advertisement
OPERATION
•
Plug the Transmitter into your instrument signal output port (guitar, bass, etc), and
plug the Receiver into your output device (amplifier, pedal, mixer, etc) input port.
For example:
Guitar > Transmitter >>> Receiver > Pedal > Cable > Amp
Bass guitar > Transmitter >>> Receiver > Mixing board
•
Press the power buttons on each device to turn on the power of both the
Transmitter and Receiver. The LED indicator lights of both devices should be green
and flashing slowly. This means the devices are not paired, but are ready for
pairing,
•
Press and hold the Pairing button on the Receiver. The LED indicator will begin
flashing rapidly.
•
Then, press and hold the Pairing button on the Transmitter. Pairing will commence,
it may take a few moments. When pairing is successful, the LED indicator lights of
the both devices will turn to solid GREEN.
•
Please charge your Transmitter or Receiver via the Micro USB port when the LED
indicator begins to display red. This represents low battery. If the device will not turn
on (no LED lights), charge until full battery before trying again.
•
This wireless system can support:
o
Six pairs of devices (1x Transmitter and 1x Receiver each) working under the
same circumstances without interference (as shown in Figure 1)
o
One Transmitter sending signal to several Receivers simultaneously
(as shown in Figure 2).
Instrument > Transmitter >>> Receiver > Amp
Advertisement
