Manual Definitions ........................3 Warnings and Cautions ....................... 3 Important Safety Instructions ...................... 4 Device Information ......................... 7 Description of the SW Advantage™ Wheelchair ............... 7 Specifications ..........................8 Unpacking and Set-Up Instructions ....................9 Unpacking/Parts Breakdown ...................... 9 Wheelchair Set-Up ........................9 Operating Instructions ........................
Page 3
Storage and Disposal......................... 27 Parts and Assembly ........................28 Warranty Information ........................30 Sizewise Rentals™, LLC (Sizewise) Limited Warranty ............30 Manufacturer Disclaimer ......................31 User Assistance Information ......................32...
Definition of Symbols Manual Definitions Throughout this manual different type fonts and icons are used to aid user readability and understanding of the content. Below are some examples. Standard Text Used for regular information. Bold Face Text Emphasizes a word or phrase. SETS APART SPECIAL...
For user and patient safety, read and follow all warnings and instructions that apply to use of the SW Advantage™ Wheelchair. Before using this wheelchair, the user must know what to do to ensure safety. Put the user at ease. The care provider should communicate with the user by telling them what they are planning to do.
Page 6
Sizewise dealer for power wheelchair options. Use of a seating system not approved by Sizewise may alter the center of balance of the wheelchair. This may cause the wheelchair to tip over and result in severe injury to you.
Page 7
Many of the screws and bolts used in the wheelchair are special high-strength fasteners. Contact an authorized Sizewise technician to assist if finding the correct fasteners. If improper fasteners are used, they could result in patient and/or user injury as well as damage to equipment or other property.
The SW Advantage™ Wheelchair is designed with the needs of the bariatric patient in mind. One Size Does Not Fit All™ which is why the SW Advantage™ Wheelchair is available from 24” (61 cm) wide up to 34” (86.5 cm) wide. Designed and engineered for bariatric individuals, this chair can hold up to 850 lbs.
Specifications Overall Width - 24” / 61 cm ................31” / 79 cm 26” / 66 cm ................33” / 84 cm 28” / 71 cm ................35” / 89 cm 30” / 76 cm ................37” / 94 cm 32”...
Unpacking and Set-Up Instructions Unpacking/Parts Breakdown Inspect for any signs of freight damage. If obvious damage is detected, contact the freight company and file a damage complaint. It may be necessary to take pictures of the damage. After visual inspection make sure all of the proper components have been received. Determining if assembly is required will depend on the method of shipping.
Operating Instructions WARNING: Keep fingers and arms away from rotating parts when mechanisms are moving. Operating this wheelchair with any part of the body in the frame can result in injury. DO NOT use the wheelchair near an open flame or an extreme heat source. Use only parts, accessories and adapters authorized by the manufacturer.
Page 12
To unfold the wheelchair: Place one hand on the seat rail that the upholstery is bolted to. Place the other hand on the rear wheel on the opposite side of the wheelchair. Simultaneously push down on the seat rail and pull out on the wheel until the seat is down. In some instances it may be necessary to wiggle the side to line up the telescope tubes.
Proper Use of the Wheelchair Center of Balance WARNING: The point where the wheelchair will tip forward, tip backward or to the side depends on the center of balance and stability. Follow the instructions in regard to center of balance to avoid a fall or injury to the user and/or care provider.
6. Pull the wheelchair toward you until the rear wheels reach the edge of the curb or step. Then allow the rear wheels to slowly roll down onto the lower level. 7. When the rear wheels are safely on the lower level, tilt the wheelchair back to its balance point.
Follow the instructions for motor vehicle safety to avoid a fall or injury to the user and/or care provider. Sizewise does not endorse or recommend the use of this wheelchair on streets or roadways. Other means of transportation must be used under these conditions.
3. The user should steady oneself by firmly grasping a rear wheel, or an armrest with one hand. 4. Make sure the user avoids putting pressure on the footrest while reaching. This may cause the wheelchair to tip forward and cause injury to the user and/or care provider. 5.
Transfers WARNING: Follow the instructions for transferring users to avoid a fall or injury to the user and/or care provider. 1. Transfers require good balance and agility and are very dangerous. Be aware that there is a point during each transfer when the chair seat is not below you. 2.
Features Armrests WARNING: Never try to lift the wheelchair by its armrests. They may come loose or break. If this occurs, the wheelchair may fall and cause injury to the user or others and could damage the wheelchair. Lift the wheelchair only by non- detachable parts of the main frame.
Casters and Pneumatic Tires WARNING: If items, such as string or hair, become entangled between the caster and the axle bolt the wheelchair may become hard to steer and roll. Check monthly and clean if needed. Proper inflation extends the life of the tires and makes the wheelchair easier to operate. Do not use this wheelchair if any of the tires are under or over inflated.
Removing the footrest: 1. Pull the footrest latch (C). 2. Swing the footrest out to an angle from the wheelchair and lift off the pins. 3. Repeat for the other footrest. Adjusting the footrest height: 1. Loosen the bolt (D) at bottom of the footrest. 2.
Rear Wheel Locks WARNING: Rear wheel locks are not designed to slow or stop a moving wheelchair. The wheelchair may veer out of control or tip over. They should only be used to keep the rear wheels from turning when the wheelchair is at a complete stop.
Positioning Belts Use positioning belts only to help support the user’s posture. WARNING: Improper use of positioning belts may cause injury or death to the user and/or care provider Make sure that the user does not side down in the wheelchair seat. If this occurs, the user may suffer chest compression or suffocate due to pressure from the belts.
See your Sizewise dealer for power wheelchair options. Use of a seating system not approved by Sizewise may alter the center of balance of the wheelchair. This may cause the wheelchair to tip over and result in severe injury to you.
Cleaning Instructions To minimize the negative impact of cleaning agents: Contact time must be monitored and kept to the required time identified on the manufacturer’s instructions. All cleaning solutions must be diluted in accordance with manufacturer’s instructions. Recommended EPA Registered Disinfectants: Wex-Cide 128 (Wexford Labs), EPA Reg.
Page 25
Avoid using harsh chemicals, such as acetone or paint thinner, as they will damage the finish of the paint. SW Advantage™ Wheelchair Periodic cleaning of the frame and upholstery is recommended. Hand wash with a non-abrasive cleaner and drip dry or wipe dry with a soft cloth. Do not put upholstery in a dryer. The frame may be polished with a non-abrasive automotive wax.
Page 26
After cleaning, all surfaces are to be wiped with a clean, dry cloth to remove any moisture or residue. NOTE: Additional cleaning may be completed, as desired, with a mild soap solution and/or household cleaning products. Avoid using harsh chemicals, such as acetone or paint thinner, as they will damage the finish of the paint.
If improper fasteners are used, they could result in patient and/or user injury as well as damage to equipment or other property. Improper fasteners may fail. Use only screws and bolts provided by an authorized Sizewise representative.
-5°C to 45°C (23°F to 113°F). CAUTION: DO NOT expose the wheelchair to humidity greater than 95%. End-of life Sizewise products must be disposed of properly according to local laws and regulations. Please contact Sizewise or your local authorities for disposal and recycling options.
Parts and Assembly ⑫ ⑪ ① ② ⑩ ③ ⑥ ⑦ ⑧ ④ ⑨ ⑤ Parts Listing PART NUMBER DESCRIPTION 2 each .....27000601....Armrest Pad 2 each .....13030030....Armrest Base 1 each .....27000604....Swing Away Footrest, Left 1 each .....27000604....Swing Away Footrest, Right 1 each ..........Footplate, Left 1 each ..........Footplate, Right 2 each .....27000121....Front Caster...
Page 30
Options not shown on the diagram on the previous page: Foot rest/Leg rest Accessories 2 each……….27000615…………..ELR Height Adjustment Lever Rod 2 each .....28000200....2” Nylon Heel Loops 1 each .....24050350L ....Left XL Footplate 1 each .....24050350R ....Right XL Footplate 2 each .....27002006....XL Calfpads Miscellaneous Accessories 1 each .....13050101....Anti-Tip Device w/Caps 1 each .....13050100....Anti-Tip Device w/Wheels...
If on-site technical service is required, a qualified service representative will be dispatched. 2. If a product or part should be returned to Sizewise, a return authorization number (RA#) will be issued. The RA# will be valid for 21 days from the date it is issued.
Manufacturer Disclaimer General Information All specifications, equipment and prices are subject to change without notice. Sizewise reserves the right to make improvements from time to time. Photos and drawings are representative of the products and may vary slightly from actual production models. Some items photographed in this user’s manual may include optional equipment.
User Assistance Information For questions or assistance with this product, contact Sizewise at: Sizewise 1600 Genessee Suite 950 Kansas City, Missouri 64102 Phone: 1-800-814-9389...
Page 34
Kansas City, Missouri 64102 Phone: 1-800-814-9389 sizewise.net Sizewise and Sizewise Rentals are trademarks of Sizewise Rentals, L.L.C. All specifications, equipment and prices are subject to change without notice. Photos and drawings are representative of the products and may vary slightly from actual production models.
Need help?
Do you have a question about the SW Advantage and is the answer not in the manual?
Questions and answers