Jumpers Setup - EverFocus eIVP-CFS-AI-D0000 User Manual

3.2 Jumpers Setup

Clear CMOS Jumper (CLRMOS1) allows you to clear the data in CMOS. Please refer to No.1 in 3.1
Motherboard Layout.
To clear and reset the system parameters to default setup, please turn off the system and unplug
the power cord from the power supply. After waiting for 15 seconds, use a jumper cap to short
pin2 and pin3 on CLRMOS1 for 5 seconds. However, please do not clear the CMOS right after you
update the BIOS. If you need to clear the CMOS when you just finish updating the BIOS, you must
boot up the system first, and then shut it down before you do the clear-CMOS action. Please be
noted that the password, date, time, and user default profile will be cleared only if the CMOS
battery is removed.
Note:
1. The Clear CMOS Button has the same function as the Clear CMOS jumper.
2. If you clear the CMOS, the case open may be detected. Please adjust the BIOS option "Clear
Status" to clear the record of previous chassis intrusion status.
The illustration below shows how jumpers are setup. When the jumper cap is placed on the pins,
the jumper is "Short". If no jumper cap is placed on the pins, the jumper is "Open".
The below illustration shows a 3-pin jumper where pin1 and pin2 are "Short" when a jumper cap is
placed on these 2 pins.
Short Open
Clear CMOS Jumper (CLRMOS1)
1_2
Default
11
eIVP-CFS-AI-D0000 AI Box
2_3
Clear CMOS