LG UT48ACP Owner's Manual page 25

PLASMA Purification Operation(Optional)
AUTO SWING OPERATION SET TEMP
Room Temp
Time
Timer Operation unit Program set
On Off
Set no. Time 01 03 05 07 09 11 13
Timer Cancel
Program Week Holiday
Plasma
SET/CLR
Hour Min
RESET
Tips for Filter sign LED
1. Filter sign lamp (LED) is ON.
2. If LED indicating filter sign lamp is ON, clean the filter.
3. After cleaning the filter, press the Timer button and
controller at the same time for 3 sec.
Then filter sign LED is OFF.
FAN SPEED SUB FUNCTION
HI AUTO Heater Preheat
MED JET Defrost Humidify
LO Filter Out door
1 2 3 4
ZONE
15 17 19 21 23
1 Press the On/Off button. The
unit will respond with a beep.
2
Open the door on the remote control.
Press the PLASMA air purifying
operation ON/OFF button.
Operation will start when
the button is pressed and stop
when the button is pressed again.
Set the fan speed again with door of the remote
3
control closed. You can select the fan speed in
four steps-low, medium, high or Auto.
Each time the button is pressed, the fan speed
mode is shifted.
Air purifying operation (PLASMA)
with cooling, heating or any
other operations.
Operating Instructions
Plasma
button of wired remote
Owner's Manual 25