6
Operation
V
CAUTION!
Follow the safety instructions in chapter
page
43.
6.1
Switching the server on and off
V
CAUTION!
If nothing appears on the screen but flickering stripes after switching
●
on the server, switch off the server immediately (see chapter
"Troubleshooting and tips" on page
The On/Off button does not disconnect the server from the mains. To
●
completely disconnect it from the mains, remove the power cords
from the PSUs.
Do not move, strike, or shake the server when it is switched on. This
●
can damage the HDD/SSD in the server and cause data loss.
Switch the server on when the temperature is in the specified
●
temperature range. For more information on the operating
environment, see
the server out of the specified temperature range, the server may
operate improperly and data loss may occur. Furthermore, Fujitsu
cannot be held responsible for any related damage, malfunction, or
loss of data, etc.
Ensure that you wait for 10 seconds or more after power off before
●
switching on the server again.
After connecting all power cords, wait at least 10 seconds before
●
pressing the On/Off button.
RX1330 M4
"Ambient conditions" on page
Operating Manual
"Important information" on
87).
99. When operating
77