Safety Camera Pois; Disclaimer; Compliance; Federal Communications Commission (Fcc) Statement - Mio Moov R503T User Manual

Safety Camera POIs

Mio products are designed to be used as an aid to safer driving. You can receive messages to alert you to
locations of safety cameras, which will enable you to monitor your speed through these areas. Mio does not
warrant that all types and locations of safety camera data are available, as cameras may be removed, relocated
or new cameras installed. Mio does not condone speeding or any other failure to comply with your local traffic
laws. It is your responsibility to drive within the posted speed limit at all times and to drive in a careful manner.
Mio accepts NO liability whatsoever for you receiving any speeding fines or points on your license through
using this device. Mio does not guarantee the accuracy of the data contained within this database either
expressed or implied. In the event you receive a fine or any other penalty for speeding or contravention of any
traffic law, or are involved in an accident, Mio is not responsible for any damages of any type. In some countries
the data information regarding safety or speed cameras may conflict with local law and/or regulations. It is
your responsibility to make sure that your use of the data is in compliance with local laws and/or regulations.
Usage is at your own risk.

Disclaimer

Due to continued product development this information may change without notice. Mio does not warrant that
this document is error-free. The screenshots and other presentations shown in this manual may differ from the
actual screens and presentations generated by the actual product.
All such differences are minor and the actual product will deliver the described functionality as presented in this
User Manual in all material respects.

Compliance

Note: Moov R503T is assigned a model number of N275.

Federal Communications Commission (FCC) statement

This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the manufacturer could void the user's authority to
operate the equipment.
118