Philips SRP3013/10 User Manual page 5

4
Enter the first 5-digit code using the digit
buttons.
5
If the light is off, a valid code is saved.
Otherwise, the light will flash six times, and
then remains on for code re-entry.
6
Operate the device with the universal
remote. If your device responds correctly,
it means you have entered the right code.
Otherwise, repeat from Step 2, and enter
the second code on the list.
Note
•
It is possible sometimes that your device only responds
to some of the buttons. In such case, set up with the
next code in the code list, and try operating your
device again. If there spill problem on code or key, you
can try to learn a key by learning faction if the remote
support learning function.
•
Each device button can be used to set up any device.
E.g. you may setup a TV using the SAT device button.
•
Before you enter any digit in Step 4 , you can press
device buttem to exit from setup mode.
EN
4
SAT
EPG
Auto registration
1
Switch on your device.
2
Press and hold the device selection button
(e.g. TV) for 5 seconds until the red LED is on.
3
Point at your device with the universal
remote.Then press and release
start searching the code for your brand.
A different infrared signal is sent every 2
seconds as the universal remote searches,
indicated by a blue flash.
SAT
EPG
INFO TEXT
to