Maintenance; Recommended Maintenance Schedule(S); Maintenance Safety; Preparing For Maintenance - Toro TimeMaster 21199HD Operator's Manual

Maintenance

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 5 hours
Before each use or daily
Every 50 hours
Every 200 hours
Yearly
Yearly or before storage
Important:
Refer to your engine owner's manual for additional maintenance procedures.

Maintenance Safety

•
Disconnect the spark-plug wire from the spark plug
before performing any maintenance procedure.
•
Wear gloves and eye protection when servicing
the machine.
•
The blade is sharp; contacting the blade can result
in serious personal injury. Wear gloves when
servicing the blade. Do not repair or alter the
blade(s).
•
Never tamper with safety devices. Check their
proper operation regularly.
•
Tipping the machine may cause the fuel to leak.
Fuel is flammable and explosive, and can cause
personal injury. Run the engine dry or remove the
fuel with a hand pump; never siphon the fuel.
•
To ensure optimum performance and continued
safety certification of the machine, use only
genuine Toro replacement parts and accessories.
Replacement parts and accessories made by
other manufacturers could be dangerous, and
such use could void the product warranty.

Preparing for Maintenance

1. Shut off the engine, remove the ignition key (if
equipped), and wait for all moving parts to stop.
2. Disconnect the spark-plug wire from the spark
plug (Figure 24).
Maintenance Procedure
• Change the engine oil.
• Check the engine-oil level and add oil as needed.
• Check the blade-brake-clutch operation.
• Clean grass clippings and dirt from under the machine.
• Check the air filter and clean or replace it, if necessary.
• Check the cutting blades.
• Clean the air filter; clean it more frequently in dusty operating conditions.
• Change the engine oil.
• Service the blade-drive system.
• Replace the air filter; replace it more frequently in dusty operation conditions.
• Service the air filter; service it more frequently in dusty operating conditions.
• Change the engine oil.
• Service the blades.
• Empty the fuel tank before repairs as directed and before yearly storage.
1. Spark-plug wire
3. After performing the maintenance procedure(s),
connect the spark-plug wire to the spark plug.
Important:
Before tipping the machine to
change the oil or replace the blades, allow
the fuel tank to run dry through normal
usage. If you must tip the machine prior to
running out of fuel, use a hand fuel pump
to remove the fuel. Always tip the machine
onto its side, with the dipstick down.
19
Figure 24
g191983