Advertisement
GRANITE BV battery series:
Presentation
1
LED gauge and push button for capacity check
2
V-bracket for battery installation
3
Contact block. The pinout in sequence is:
Pack negative (+ve)
ID resistor
Data communication bus (clock)*
Data communication bus (data)*
Pack positive (-ve)
4-5
Twin D-TAP sockets 14.8V(nominal)/5A with overload
protection*
1
*
The purpose of data communication is to send battery status
information to those cameras and devices that are compatible with
the
battery
communicate with a standard PC through our BSMON kit. Full
technical information is available on our web site.
2
*
The combined output from both D-TAP sockets should not exceed
70W. Above this value, the D-TAP protection circuit intervenes,
4
disconnecting the output on both sockets but without effecting the
battery operation through the main terminals. The power is
automatically resumed by removing the overload condition from the
D-TAPs.
The total output power of the battery and D-TAPs should not exceed
100W. Above this value, the battery will go into main protection but
will resume operation a few seconds after the overload condition has
been removed.
2
communication
1
1
protocol.
The
battery
can
also
Advertisement
