Lark SKIMMERPLUS SFX330 Owner's Manual page 14

®
5. Slowly take out the Motor Assembly
Rubber Nozzle or Canister Gasket
2
STEP 2: Rotor Inspection/Replacement
The Pump is consisted of a Rotor Assembly
3
seated in place between the Volute Cover
1. Loosen the Volute Cover Screws
2. Pull the Rotor Assembly out from the Pump Body
k
Inspect the Rotor (see image below) to make sure that the Rotor Shaft, Magnet Axle, Impeller and other parts are intact. If either of them is broken, you can
purchase a new Rotor Assembly at polygroupstore.com without having to replace the whole Pump.
For more details, please see Pool Support – Filtration System Troubleshooting at support.polygroupstore.com
3. Once the inspection or replacement is done, carefully insert the Rotor Assembly
down in place.
4. Align the Volute Cover with the top Shaft End Cap, then tighten with the Volute Cover Screws
l
5. Attach the Rubber Nozzle to the outlet of the Pump Body
2
2
14
. Be careful not to lose the
3
.
4
and its related parts. If the Rotor and/or its parts is/are broken, or the Rotor, even in perfect condition, is not
k
and Pump Body , the Pump will not function properly.
l z
, and remove the Volute Cover
; l
.
z
.
z
29
28
27
4
2
.
back into the Pump Body
k
.
;
Rotor Assembly Parts
30
You may need to reach inside the
Canister to free the Pump Motor.
3
The force of the magnet will pull the Rotor
z
Shaft End Cap
Washer
Impeller
Magnet Axle
Rotor Shaft
(This shaft should go through
all the parts and into both
Shaft End Caps)
Washer
Shaft End Cap